What bathroom waterproofing after plumbing includes
- Checking the bathroom floor slope toward the drain and confirming the surface is level
- Checking pipe and drain openings to confirm they are ready for waterproofing
- Treating the junctions between the floor and walls before the waterproof layer is applied
- Sealing around the drain and every pipe opening as part of the waterproof layer
- Applying waterproof material to the floor and up the walls to the required height
- Confirming the layer covers every weak point before the tiler arrives
From your call to the waterproof layer
- 1
Describe the current state
Call or message us on WhatsApp and tell us how far the plumbing has gone and the size of the bathroom, so we understand what the job needs.
- 2
We check the floor and openings
We check that the floor slopes toward the drain and inspect the pipe and drain openings to confirm they are ready to be sealed around.
- 3
We prepare the surface
The floor and walls are cleaned, the corners and pipe openings are treated before any material goes down, because the layer does not hold on an unprepared surface.
- 4
We apply the waterproof layer
The waterproof material is applied to the floor and up the walls to the required height, with close attention to the corners, around the drain and at every pipe opening.
Waterproofing starts with checking, not the material
- We check the floor slope before waterproofing
- We seal around pipe openings and the drain
- We treat every corner before the tiles go down
- Waterproofing covers the floor and the wall bases
- We take your request by phone call or WhatsApp message
The service in Al Jishshah
In a district like Al Jishshah, bathrooms and kitchens face constant moisture from daily use and showers. A strong waterproof layer after plumbing stops water entering walls and foundations under the tiles. The surface is cleaned and prepared, then the floor, walls and joints are coated with a material (epoxy or bitumen) that blocks water. The first check identifies any cracks or existing damp that need treatment before coating.
Al Jishshah is a district in Al-Ahsa governorate in the Eastern Province, close to Al Markaz, Al Jafr and As Sabat.
Salt in foundation water speeds concrete decay, so waterproofing reduces moisture absorption from the ground.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
ممتاز والخدمة ان شاء الله تكون قد التوقعات
- ★★★★★
شغلهم ميه ميه يشكرو عليه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Bathroom waterproofing after plumbing in Al Jishshah
Work can start once plumbing is complete, the screed is set and dry, and the pipe openings and drain are in their final positions. Starting before those are settled risks having to redo the work.
Because they are transition points between two surfaces or two materials, and those points experience slight movement as the structure expands and contracts. A flat layer on a single surface handles that better than junctions do, which is why each corner and each pipe opening needs its own treatment.
After-plumbing waterproofing is the earlier stage: here the floor slope is checked and pipe openings and drains are treated before you reach the application stage. Before-tiling waterproofing comes next, when the floor is ready and the layer is applied in preparation for the tiler.
Usually yes. The bathroom floor faces constant water and foot traffic and needs a material that holds under continuous pressure. The walls around the shower area need a layer that holds vertically and resists repeated moisture. The areas around the drain and pipe openings often need extra spot treatment before the main layer.
Confirm that all water supply and drain pipes are in their final positions and will not move, that the screed has been poured and dried, and that the drain is fixed at the right height. Any plumbing change after the waterproof layer is applied means cutting through it and retreating that spot.
Tell Al Raya about the state of pipes and drains, whether you see damp spots on walls or floor, which floor the bathroom is on, and send a photo on WhatsApp.
No, but the waterproof layer needs time to dry completely before tiling. Any damp that appears right after finishing may come from moisture in older concrete, which fades as it dries.
More services in Al Jishshah
Bathroom waterproofing after plumbing in nearby areas
