What bathroom waterproofing after tiling includes
- Inspecting the joints between tiles and the corners at the wall base to find where water enters
- Checking the openings where drain and water pipes pass through the floor or wall
- Assessing whether treatment is possible without lifting tiles or requires it
- Preparing the surface by removing worn and loose material before any treatment is applied
- Treating the joints, corners and openings with the material suited to each, such as epoxy or a flexible sealant
- Sealing the corners with a flexible material that absorbs movement and prevents water re-entering
From your call to the treatment
- 1
Tell us what you see
Call or message us on WhatsApp and describe the stain, where it is, and whether it appears only after the bathroom is used or all the time.
- 2
We inspect the entry point
We check the joints between tiles, the corners at the floor and wall, the drain opening and the pipe entries to find where the water is getting in.
- 3
We assess what can be treated without lifting tiles
When the damage is limited to joints, openings and corners, these can be treated directly. If the layer under the tiles has failed widely, lifting the tiles becomes necessary to lay a new layer.
- 4
We treat and seal
We treat the joints, openings and corners with the material suited to each, and surfaces are prepared before any treatment, because working on a dirty or loose surface produces no real result.
The problem can be treated
- We find the water source before any work
- We treat joints, corners and openings
- We inspect the floor, walls and drain
- We use epoxy and appropriate materials
- We take your request by phone call or WhatsApp message
The service in Muraytibah
A bathroom in a small or medium home in a settlement like Muraytibah is often weak in water protection, especially if the house is older or built on damp ground. Leaks start from tile joints, cracks in walls or drainage pipes that pass through the wall. Water entering the wall may not show in the bathroom itself, but as stains on ceilings or walls in adjoining rooms. Al Raya inspects the bathroom and surrounding areas to trace the water path, then treats joints, cracks and pipes as the inspection reveals.
Muraytibah is a small settlement in Al-Ahsa governorate in the Eastern Province, close to Sudah, Al Ghuwaybah and At Taraf.
Water from a bathroom may descend and show as stains on the ceiling in the room below or beside it, so inspection starts in the bathroom itself.
Our portfolio
What our customers say
- ★★★★★
شركة ممتازة تستحق التعامل معها بشكل مستمر
- ★★★★★
شكراً لخدمتك الجميلة
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Bathroom waterproofing after tiling in Muraytibah
Treating the joints means removing worn grout, refilling the joints and sealing the corners and openings. It suits cases where the damage is limited to those areas. Full re-waterproofing means lifting the tiles and laying a new layer, and is only needed when the original layer has failed across a wide area or was never there.
In some cases it is possible to reach the joints or cracks from the other side, that is from the ceiling or wall below or beside the bathroom, and inject a sealing material from there. Whether this is suitable depends on where the water enters and how wide the damage is, and it does not suit every case.
Epoxy is a resin that hardens into a solid water-resistant layer, and it is used to fill joints, seal openings and corners. It needs a clean, dry and sound surface before it is applied. If the tiles are poorly bonded or the floor beneath them is crumbling, epoxy alone is not enough and lifting the tiles may be necessary.
The corner between the floor and the wall is the area most exposed to structural movement and to pooling water. Even when a waterproof layer is laid before tiling, the corner needs an additional seal with a strip or a flexible material that absorbs movement. When tiles are laid directly without a layer or without sealing the corner, this becomes the first point where water enters.
If the damp appears in a specific spot tied to a joint, corner or opening, and the tiles are firm and the floor beneath them is sound, treating the joints directly is a reasonable option. But if stains appear across wide areas that do not match any particular joint, or if tiles are hollow or moving, the layer beneath them has likely failed across an area that sealing joints alone cannot fix. An inspection is what determines this accurately.
Because water enters the wall from the bathroom and travels inside it horizontally or vertically before showing on another surface. This means the leak could be in your bathroom but the stains appear in an adjoining or lower room.
Say exactly where the stains appeared, how long you have noticed them, whether the bathroom is heavily used, and whether the house has had leaks before, and photos on WhatsApp help a lot.
More services in Muraytibah
Bathroom waterproofing after tiling in nearby areas
