
From your call to the inspection result
- 1
Tell us what you need
Call or message us on WhatsApp and tell us whether it is a villa before handover, a building you are thinking of buying, or one you are about to rent.
- 2
We check what you cannot see
We pass moisture meters and a thermal camera over the roof, the walls, the bathrooms and the networks to find hidden damp and leaks.
- 3
We locate the defects
We tell a surface crack from a deep one, and passing damp from a continuing leak, because each calls for a different treatment.
- 4
You know what you are facing
After the inspection you know where the problem is and what caused it, and you decide how to act before handover or before closing the deal.
Relax, the inspection answers your question
- We find damp and leaks with instruments, not guesswork
- We check the roof, walls, bathrooms and water network
- We tell construction defects from operational ones
- We take your request by phone call or WhatsApp message
- An inspection protects you before you decide to take or buy
The service in Ash Shi’bah
In a district like Ash Shi'bah, homes face ground moisture and rising salts, especially on lower floors and in foundations. There may be a leak from the roof, tanks or pipes around the building. Cracks may appear in external walls from building movement or water, and dark or white patches may show hidden damp. The team checks every part of the building with instruments that read damp, salts and faults, starting from the roof and working down to the foundation. A thorough inspection shows whether the problem is surface-level or deep, and helps you make the right choice.
Ash Shi'bah is a district in Al-Ahsa governorate in the Eastern Province, close to Al Qurayn, Julayjilah and Ash Shuqayq.
Inspection focuses on the joints between walls and ceilings and around windows and doors, because water enters through these places first.
Our portfolio
What our customers say
- ★★★★★
شغلهم ميه ميه يشكرو عليه
- ★★★★★
شكرا على التواصل وصلو في اسرع وقت ممكن
- ★★★★★
ممتاز والخدمة ان شاء الله تكون قد التوقعات
Reviews are shown as the customers wrote them, in Arabic.
Questions about Building & villa inspection in Ash Shi’bah
A leak check looks for the source of an existing problem. A pre-handover building inspection looks for defects that may not have appeared yet: damp inside a wall, structural cracks, poor roof drainage, a hidden leak in the network. The aim is to know before you take on legal responsibility.
We check the building roof and its drainage and parapet, the internal and external walls for damp and cracks, the bathrooms and kitchens together with their water and drain networks, and the top-floor areas that are first affected by leaks from above.
A moisture meter reads how much moisture the wall holds without touching its interior, giving a surface reading. A thermal camera shows the temperature difference between a dry area and a wet one, which maps the roughly affected zone. Both instruments guide the inspection before anything is opened.
A hairline crack in the paint layer alone often points to no structural issue. A crack that runs in one direction, widens gradually or sits at a construction joint often points to movement or stress in a structural element. An inspection is what tells one case from the other.
A new building can carry construction defects that have not surfaced yet: roof waterproofing applied incompletely, drainage laid at the wrong fall, or water network joints never tested under real pressure. These defects usually appear after the first rainy season or after the network has been in use for a period.
Yes, and often more than for a new building. An older property may carry a history of temporary repairs that covered defects without treating them. Accumulated wall damp, old cracks and leaks patched with a layer over the problem all show up in an inspection before you take them on.
Tell us whether it is a villa, a residential unit or a commercial property, whether the inspection is before taking from a contractor, before buying or before renting, and whether you notice anything now such as damp patches, wall cracks or a smell. These details help us decide what to check first.
Surface damp may be from condensation or water spray, while deep damp comes from a long-standing leak or groundwater. Instrument inspection tells them apart and pinpoints the source accurately.
Small cracks may be natural from the building expanding and shrinking, but if they are growing or in a line they may signal deeper movement. Inspection tells you whether to worry.


















