What plaster crack repair includes
- Checking the plaster layer by tapping and direct inspection to find hollow sections and areas that have separated
- Identifying why it cracked: drying too fast, the mix ratio or poor bonding to the surface behind it
- Removing the hollow and cracked plaster and cleaning the base surface ready for repair
- Re-plastering the treated areas to suit the wall type and the required finish
- Treating fine surface cracks where the layer behind them is sound and properly bonded
- Answering your questions about plaster crack repair before the work starts
From your call to a sound wall
- 1
Describe what you see
Call or message us on WhatsApp, and tell us where the cracks are, what they look like, and whether the wall sounds hollow when you tap it.
- 2
Inspect and diagnose the layer
We check the plaster by tapping and direct inspection to find where the layer is hollow or has separated from the surface behind it, and to identify the cause of the cracking.
- 3
Remove the weak areas
The damaged and hollow plaster is cut out fully until the base surface is exposed, because filling cracks over a loose layer does not hold the finish.
- 4
Re-plaster onto the prepared surface
After the surface is ready, the treated areas are re-plastered to suit the wall type and the required finish so they blend with the surrounding surface.
The wall becomes sound again
- We tell a plaster crack from a crack in the wall behind it
- We find hidden hollow sections by direct inspection
- We remove the weak layer before any repair
- We re-plaster onto a properly prepared surface
- We take your request by phone call or WhatsApp message
The service in ’Uray’irah
In a village like 'Uray'irah, home walls suffer cracks from several causes: moisture and salts from wet soil, slight movement in the masonry, and rapid drying of plaster under intense heat. Cracks may appear deep or shallow, and spread quickly if left untreated. Repair begins with cleaning them of dust and loose material using special tools, then injecting strong adhesive, and finally filling and smoothing the surface. Before starting, the whole wall is inspected to understand the cause of the cracks, especially if damp is present.
'Uray'irah is a village in Al-Ahsa governorate in the Eastern Province, close to UmmTali, Umm Rubay'ah and Umm al Hamam.
Cracks in villages surrounded by farmland with wet soil usually start from the foundation and run up the walls.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شغلهم كويس وناس ممتازه في اسرع وقت
- ★★★★★
شغلهم ميه ميه يشكرو عليه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Plaster crack repair in ’Uray’irah
A network of fine surface cracks that looks like a map usually stays in the plaster layer alone. A single wide crack that extends and widens over time often reaches the wall behind it. Tapping with a knuckle helps: a hollow sound means the layer has separated from what is behind it.
The common cause is drying too fast, particularly in hot dry weather. The mix ratio of water or sand, a dry surface that was not wetted before application, or applying too thick a layer without waiting can all be causes. These factors affect how the layer holds even if the wall looks sound at first.
If the plaster behind the cracks is properly bonded and there is no hollow section, filling fine cracks with a flexible material before painting may be enough. But if the layer is hollow under the surface, any finish above it is temporary, because the layer will eventually come away and take the finish with it.
Yes. The job starts by identifying the hollow or cracked areas precisely, then those areas are removed and replaced without disturbing the sound plaster around them. The aim is to remove what is actually weak, nothing more. The area to be removed is determined after inspection, not before.
Tell us where in the house the cracks are, whether they look like a fine network or a single extending crack, whether the wall sounds hollow when tapped, and whether there is any damp or peeling alongside them. These details help us decide what needs to be checked first.
The causes may be multiple: moisture from surrounding soil, slight natural movement in the masonry, and rapid plaster drying in heat. If cracks are widespread across several walls, inspection determines whether the cause is general dampness or movement in the foundation itself.
No, wet cracks need moisture treatment first before plaster repair, either by protecting the wall from groundwater or improving drainage around the house. Then the cracks themselves are treated. Initial inspection sets the right plan of action.
