Al Raya
Detect-and-repair package in Juba District: An opened tiled floor with a new pipe coupling and a detector resting beside it

Detect-and-repair package in Juba District

In Juba District, pipes and tanks may leak without the water showing directly at the source. Al Raya uses advanced techniques to find the leak and repair it at once.

What the service includes

What detect-and-repair includes

  • Checking the affected area and its surroundings to trace the water path and find the actual source
  • Telling apart a pipe leak, a joint leak and a surface or wall leak
  • Checking pipes, connections and visible joints in the identified area with instruments
  • Deciding the right type of repair for each source before treatment begins
  • Treating the leak point with the right material: epoxy, bitumen or polyurethane foam
  • Explaining to the homeowner what was found and what was treated after the work is done
How we work

How the work goes from the start

  1. 1

    Describe what you see

    Call or message us on WhatsApp and tell us where the damp appears, and whether it shows constantly or after rain or use.

  2. 2

    We find the source with instruments

    We check the affected area and what is above and around it to tell apart a pipe leak, a joint leak and a surface or wall leak.

  3. 3

    We decide the right repair

    The repair differs with the source: a crack in concrete needs different treatment from an open joint or a broken pipe.

  4. 4

    We treat the leak point

    We treat the identified point with the right material, whether epoxy, bitumen or polyurethane foam, according to the surface and the source.

Why Al Raya

Why homeowners feel at ease with us

  • We find the source before any repair
  • We inspect without breaking or demolishing
  • The repair is at the actual leak point, not where it appears
  • We treat pipes, joints, cracks and surfaces
  • We take your request by phone call or WhatsApp message
About the area

The service in Juba District

In a home in a district like Juba, water pipes often run across large areas, and tanks may be high, low or in hard-to-reach places. Damp from a tank or pipe may take time to reach a wall or floor, appearing far from its source. Al Raya's team checks the entire network, tanks, joints and corners, then pinpoints the leak with instruments and treats it in place. This may require pipe repair, crack sealing or improved waterproofing.

Juba District is a district in Al-Ahsa governorate in the Eastern Province, close to Al Mirqab District, Ladhah District and Al Marbidia District.

Leaks in buried pipes and raised tanks are hard to spot directly and require specialist instruments to detect.

Read about Detect-and-repair package

Our work

Our portfolio

  • Peeling paint on an exterior wall beside a pipe
  • A hole in a broken wall exposing pipes and wires
  • Cracked and bubbling paint along a wall edge
  • A hand scraping damp mortar from between small stones on a surface
  • A leak detection device with headphones in a case
  • Damp stains and damage on a ceiling beside a wall light
Reviews

What our customers say

  • ★★★★★

    شكرا على التواصل وصلو في اسرع وقت ممكن

  • ★★★★★

    شكراً لخدمتك الجميلة

  • ★★★★★

    شركة ممتازة تستحق التعامل معها بشكل مستمر

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Detect-and-repair package in Juba District

Water moves inside the wall or ceiling before it shows on the surface, so the stain often appears lower than the source or on a different side. That is why repairing only where you see it is not enough unless the actual source is found first through inspection.

This approach suits leaks whose source is unknown, when you cannot tell whether the water comes from a pipe, a joint, a wall crack or the roof. Larger leaks that need extensive repair work may call for a separate assessment.

Common materials include epoxy, a resin coating that hardens, used on surfaces and cracks; bitumen, a rolled membrane that suits horizontal surfaces; and polyurethane foam, a sprayed foam that fills gaps. The choice depends on the surface, the leak point and the type of source.

If the source is a crack or open joint in the exterior wall, treatment can usually follow detection straight away. However, some walls carry damp from several sources, and in that case the scope of repair is set after the full inspection.

No demolition or breaking is needed from your side. Keep the affected area as accessible as possible, and note whether the damp worsens at certain times or after certain use, as these details shorten the inspection and help pinpoint the source.

Detection with instruments pinpoints the leak precisely, and repair follows directly: treating the leaking pipe, tank or joint. Both come together in the service.

Persistent damp, a musty smell, accumulated salt or stains on walls and ceilings are clear signs of a leak. Instrument checking locates the source.

Nearby areas

Detect-and-repair package in nearby areas

Sunset over villa roofs and palm trees

Describe what you see and we start

Call or WhatsApp us and tell us where the damp is in your home.

Call nowWhatsApp