Al Raya
Roof waterproofing in Al Ahsa: A worker rolling white insulation coating onto a villa roof

Roof waterproofing in Al Ahsa

Roof waterproofing in Al Ahsa protects homes from water leaks and the intense heat that bears down on flat roofs all year. Al Raya inspects the roof first, then applies a sealed waterproof layer with materials suited to the city's conditions.

How we work

From your call to a treated roof

  1. 1

    Tell us what you see

    Call or message us on WhatsApp and tell us what you notice: a damp patch, peeling paint, heat on the top floor, or cracks you can see on the roof.

  2. 2

    We inspect the roof

    We read the condition of the existing layer and locate the cracks, joints, drains and the base of the parapet, as each is a potential entry point for water or heat.

  3. 3

    We prepare the surface

    A layer will not hold on an unprepared surface. Preparation includes treating cracks, cleaning the drains and levelling low spots before any waterproofing material is applied.

  4. 4

    We apply the right system

    We choose from bitumen rolls, epoxy coating or sprayed polyurethane foam according to what the inspection reveals, and we give the joints and edges the care they need.

Why Al Raya

What makes the difference in this work

  • We read the roof before choosing the waterproofing material
  • We treat cracks, joints and roof drains
  • Three systems: bitumen, epoxy and polyurethane foam
  • We take your request by phone call or WhatsApp message
  • Cost depends on the roof's condition and you find out by contacting us
About the area

The service in Al Ahsa

Flat roofs in Al Ahsa city are exposed to water when rare rains fall and to intense summer heat for months. The roof usually has joints around the parapet, drains, tanks and stair covers, and water enters these places first. Work begins with a careful inspection of the existing surface, cracks and damp, then the roof, joints and parapet edges are prepared for a sealed waterproof layer. This treatment closes openings and shields the roof from both heat and water.

Al Ahsa is a city in Al-Ahsa governorate in the Eastern Province, close to As Saifa District, Ayn Najm District and Al Muhammadiyah District.

Water collects at the parapet edge and around the drains, and these are the first points the team checks on arrival.

Read about Roof waterproofing

Our work

Our portfolio

  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
  • A building roof covered in white insulation
  • A roof covered in white insulation with a worker in the distance
  • A white roof with an air conditioner and satellite dishes
Reviews

What our customers say

  • ★★★★★

    شغلهم نظيف وسريعين ومحترمين الله يعطيهم العافيه

  • ★★★★★

    شركه ممتاز شغلهم كويس ويعطيهم العافيه

  • ★★★★★

    شركة ممتازة تستحق التعامل معها بشكل مستمر

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Roof waterproofing in Al Ahsa

It depends on the condition of the old layer. If it is intact and bonded to the surface it may serve as a base. If it is cracked, blistered or loose, removing or treating it first is what allows the new layer to hold. Applying a layer over an unprepared surface brings the problem back.

The most common entry points are hairline cracks in the concrete, the joints where the roof meets the parapet, and around the base of drains, pipes and air-conditioner stands. The smooth middle of the roof is less exposed than these edges and joints, so they deserve special care during waterproofing.

Waterproofing stops water getting in through cracks and joints. Heat insulation reduces how much heat passes down into the rooms below the roof. A roof may need one or both, and waterproofing is often treated first because damp under a heat-insulating layer weakens it. We inspect the roof to decide what it actually needs.

Three main systems: bitumen rolls, which are rubber-like membranes laid in overlapping strips and sealed at edges and joints; epoxy, a resin coating that hardens into a water-resistant layer; and polyurethane foam, sprayed on and expanding to cover the surface including small details. Choosing between them depends on the roof's condition and the nature of the problem.

They are two separate problems but can sometimes be treated together. Some waterproofing materials add a modest amount of heat insulation, but a roof that suffers serious heat often needs a dedicated heat-insulating layer alongside the waterproofing. We inspect the roof and decide what is enough and what needs adding.

Water travels sideways through the concrete before it drops, so the stain appears away from where it entered. Searching only at the ceiling does not reveal the source. The right inspection starts at the roof and at the known weak points such as joints and drains, not at the ceiling stain.

Tell us where the damp appears inside or what you see on the roof: cracks, blisters or an old layer. If the problem is heat, tell us which floor you live on and whether you notice a difference between rooms. The clearer your description, the easier it is to decide what the roof needs.

Look for damp stains or discolouration on the ceiling from inside, or notice leaks after rain, or damp in the upper walls; these show water is entering from the roof. Call and describe clearly what you see.

The roof is checked for cracks and joints between sections, the parapet and drain condition, the position of water tanks and pipes, and whether damp already exists under the old layer, because the roof must be dry before waterproofing.

Nearby areas

Roof waterproofing in nearby areas

Sunset over villa roofs and palm trees

Describe your roof and we find the step

Call or WhatsApp us and tell us what you see on the roof or inside the house.

Call nowWhatsApp