Al Raya
Roof heat insulation in Ash Shuqayq: The edge of a roof insulated in white beside a building under a clear sky

Roof heat insulation in Ash Shuqayq

In Ash Shuqayq, flat roofs bear intense sun heat, and the rooms below feel it directly. Al Raya insulates the roof with sprayed polyurethane foam, cutting heat entry into the home.

What the service includes

What roof heat insulation includes

  • Checking the concrete roof condition to identify what needs treating before insulation
  • Finding cracks and joints that need repair before the layer goes on
  • Preparing, cleaning and levelling the surface so the layer bonds properly
  • Applying sprayed polyurethane foam or epoxy coating according to the roof condition
  • Covering edges, joints and the base of the parapet to complete the insulation
  • Treating any water leak found during inspection before the heat insulation is finished
How we work

From your call to an insulated roof

  1. 1

    Tell us what you feel

    Call or message us on WhatsApp and describe which floor gets hot and which rooms are affected, and we will decide with you what needs to be checked.

  2. 2

    We inspect the roof first

    We check the roof condition before anything else, because a roof with cracks or standing water needs waterproofing before the heat-insulating layer goes on.

  3. 3

    We prepare the surface

    The job involves cleaning the surface and levelling what needs levelling, because a layer only works as it should on a clean and ready surface.

  4. 4

    We lay the heat-insulating layer

    We choose between sprayed polyurethane foam and epoxy coating according to the roof condition and what is needed, and we cover the whole area including the edges and joints.

Why Al Raya

An insulated roof makes a difference in the rooms below

  • We inspect the roof before insulating to choose the right layer
  • Polyurethane foam covers edges, joints and corners
  • Epoxy is a hard coating that reflects heat and protects the surface
  • We treat cracks and leaks before the heat-insulating layer goes on
  • We take your request by phone call or WhatsApp message
About the area

The service in Ash Shuqayq

Homes in a district like Ash Shuqayq usually have flat roofs, directly facing summer heat. Roofs typically have a parapet, drains, water tanks, and possibly a stair cover or stairs. Each joint between these parts is where heat and moisture can enter the ceiling and rooms. Foam is sprayed continuously and seamlessly, leaving no gaps, so it suits roofs with many corners and joints. But the roof must be dry and clean of damp before work starts.

Ash Shuqayq is a district in Al-Ahsa governorate in the Eastern Province, close to Al Mutayrifi, Al Qurayn and Julayjilah.

Small cracks and joints are the first entry points for heat, especially around the parapet, drains and tanks.

Read about Roof heat insulation

Our work

Our portfolio

  • A white roof with an air conditioner and satellite dishes
  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
  • A building roof covered in white insulation
  • A roof covered in white insulation with a worker in the distance
Reviews

What our customers say

  • ★★★★★

    ممتاز والخدمة ان شاء الله تكون قد التوقعات

  • ★★★★★

    شكرا على التواصل وصلو في اسرع وقت ممكن

  • ★★★★★

    شركه ممتاز شغلهم كويس ويعطيهم العافيه

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Roof heat insulation in Ash Shuqayq

Heat insulation aims to stop the sun's heat passing from the concrete roof into the rooms below, which shows in the top floor in summer. Waterproofing aims to stop water entering through cracks and joints. A roof often needs both, and inspection decides which comes first.

A layer on its own does not seal cracks; it goes on a ready surface. If the roof has cracks or areas that have held water before, treating them comes before the heat-insulating layer, otherwise the problem stays under the new layer.

Polyurethane foam is a sprayed foam layer that fills edges, corners and joints and insulates well. Epoxy is a resin that is applied as a coat and hardens, reflecting heat and protecting the concrete. Choosing between them depends on the roof condition and what it needs.

Roof heat insulation treats the transfer of heat through the concrete into the rooms below. Wall dampness has its own causes, often water entering through joints or cracks in the wall or roof. Inspection identifies the source of the dampness before any treatment.

Heat insulation suits exposed concrete roofs where heat transfer is the main problem. If the roof has wide cracks, standing water or a badly worn old layer, the work starts with assessing the roof condition and deciding what to treat first before the right heat-insulation method is chosen.

Say that the top rooms heat up in summer, whether the ceiling is hot, if you see damp or water marks on it, and whether the roof has tanks or a stair cover. Send a photo on WhatsApp if possible.

Foam insulates from heat, but cracks and joints are checked first. If they are deep or let water in, they may need fixing before foam, and the team will advise you.

Nearby areas

Roof heat insulation in nearby areas

Sunset over villa roofs and palm trees

Call and we start with the roof

Call or WhatsApp us and describe the roof and the rooms that get hot.

Call nowWhatsApp