The stages of a tank clean
- 1
Tell us your tank type
Call or WhatsApp us and tell us whether the tank is in the ground or on the roof, what it is made of, and what you have noticed in the water.
- 2
Emptying the tank fully
The clean starts by removing all the water so the floor, walls and corners can be reached, because sediment and silt cannot be properly removed without full emptying.
- 3
Scrubbing and removing the build-up
Algae, sediment and rust are scrubbed from the walls and floor of the tank, then removed completely from the inside before rinsing.
- 4
Rinsing until the water runs clear
The tank is rinsed with water until it runs clear with no cloudiness, and the tank is then ready to fill or to sanitise if needed.
What makes this work worth doing
- Sediment at the bottom does not clear with water changes alone
- Algae grows in any tank that gets light
- Cleaning algae from a tank needs actual scrubbing of the walls
- We take your request by phone call or WhatsApp message
- We work with ground tanks, overhead tanks and fibreglass tanks
The service in Al Kilabiyah
In a town like Al Kilabiyah, the tank is used every day, and sediment and algae build up slowly but steadily. Groundwater in Al-Ahsa contains minerals and salts, which settle at the tank bottom over time. Microorganisms or algae may grow on tank walls if light or contaminated air enters. Proper cleaning removes these deposits and organisms from all internal tank surfaces. The tank should be inspected first to identify what is contaminating it and how much.
Al Kilabiyah is a town in Al-Ahsa governorate in the Eastern Province.
Mineral and organic deposits gather on the bottom and walls, and these are the main causes of bad smell, cloudiness and discolouration.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شكراً لخدمتك الجميلة
- ★★★★★
شغلهم ميه ميه يشكرو عليه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Water tank cleaning in Al Kilabiyah
The clearest signs are an unusual smell from the tap, a yellow or cloudy colour, or small particles floating in a glass. If there is no obvious sign, periodic cleaning is still needed because sediment builds up even before it becomes visible.
Yes. A ground tank is usually larger, entered through a top hatch, and collects more sediment at the bottom. An overhead tank is exposed to sunlight so algae forms faster. A fibreglass tank has walls that scratch, which needs appropriate tools. Each type has its own way of working.
Cleaning removes the visible sediment and algae. Sanitising treats what may remain on the walls after cleaning. It is often a good idea to follow a clean with sanitising, especially if the smell was strong or the tank has not been cleaned for a long time.
No, emptying is part of the cleaning process itself. Just let us know the approximate size of the tank, its location, and whether it is a ground or overhead tank, and we will handle the rest when we arrive.
Cleaning is a condition for any repair because the wall must be clean and dry before treatment. If there is a leak or a lining failure, it is treated after cleaning is complete. We tell you what your tank needs when we inspect it.
The old water is fully removed from the tank before work begins, which is necessary to reach the floor and properly remove the sediment. After rinsing and the work is complete, the tank can be refilled with clean water.
Tell us the tank type, whether it is a ground or overhead tank, what it is made of as far as you know, what you notice in the water such as a smell, a colour or particles, and whether it has been cleaned before. These details help us suggest the right service for you.
If you notice a foul smell from the tap, or if the water becomes cloudy, yellow or brown, or if you taste something odd, the tank needs careful cleaning from inside.
They check the tank location and exterior condition, look at the water colour and smell, verify the inlet and outlet positions, and whether the tank is cracked or leaking.
More services in Al Kilabiyah
