Overhead tank leak detection in Az Zahrah District
Overhead tank leak detection in Az Zahrah District locates the source with specialist instruments without breaking the tank or roof. If you see a damp stain on the ceiling or water pooling under the tank, Al Raya finds exactly where it leaks.
What overhead tank leak detection includes
- Checking the tank body and base with detection instruments for cracks or weak points
- Checking the inlet and outlet pipe joints where they pass through the tank wall
- Checking the float valve to tell a real leak from drainage through the overflow
- Checking the roof slab around the tank to see whether water is spreading beneath it
- Checking the nearby wall when damp appears on the top floor
- Writing down the leak location and cause in a certified report after inspection
From your call to knowing the source
- 1
Tell us what you see
Call or message us on WhatsApp and describe where the stain or damp is, and whether it appears constantly or grows after the tank fills.
- 2
We check the tank with instruments
We pass detection instruments over the tank body, its base, its joints and the surrounding slab, without breaking anything and without fully emptying the tank.
- 3
We pinpoint the source
We tell apart a crack in the tank body, a leaking pipe joint, a faulty float valve and water running across the slab from elsewhere, because each needs a different repair.
- 4
You receive a certified report
We document the tank leak location and its cause in a certified report after inspection, so you know exactly what needs to be repaired.
Relax, the source of the water can be found
- We find the leak without breaking anything
- We tell a float fault from a real leak
- We check the tank, the joints and the roof slab
- Certified report after inspection
- We take your request by phone call or WhatsApp message
The service in Az Zahrah District
In a district like Az Zahrah, homes have large overhead tanks for the family's needs, and any leak from them shows quickly on the ceiling below or on the slab around the base. The technician checks the tank, inlet and outlet pipes, metal joints and concrete base for cracks and tiny holes. Special instruments detect water without opening the tank, because a fine leak may not be visible. The surface must be clean before checking for a clear view.
Az Zahrah District is a district in Al-Ahsa governorate in the Eastern Province, close to Al Jamiyin District, Al Iskan 1st District and Al Hamra 1st District.
Most overhead tank leaks happen at pipe joints, around the tank base and in tiny cracks in the metal body.
Our portfolio
What our customers say
- ★★★★★
شغلهم نظيف وسريعين ومحترمين الله يعطيهم العافيه
- ★★★★★
شغلهم ميه ميه يشكرو عليه
- ★★★★★
شركة ممتازة تستحق التعامل معها بشكل مستمر
Reviews are shown as the customers wrote them, in Arabic.
Questions about Overhead tank leak detection in Az Zahrah District
Rainwater disappears once things dry out and returns only with rain. Water from the tank comes back in the same spot on dry days too, and it often leaves a white salt mark on the slab after it evaporates. If you see constant damp around the tank base regardless of the weather, it is most likely a leak worth checking.
Yes, and it is a point many people overlook. The joint between the pipe and the tank wall is exposed to pump vibration and the thermal expansion of the tank, so the opening can widen gradually and water can escape around it rather than through the pipe. Instrument inspection tells whether the damp is at the joint itself or from somewhere else.
The two most common causes are a crack in the tank body or base, or a float valve that does not close and keeps the inlet open so water drains through the overflow. The difference matters because the repair is different in each case. Inspection finds whether water is leaving the tank itself or returning to the supply through the valve.
Yes, especially when the tank is close to the parapet or the wall of the top floor. Water seeps into the slab and travels through the path of least resistance, so the damp can appear on an interior wall rather than, or alongside, the ceiling. That is why inspection covers the slab around the tank and the nearby wall together.
Tell us where the damp appears: on the roof around the tank, or on the ceiling or wall of the floor below. Tell us whether it is constant or appears only after the tank fills. If you hear a continuous flow sound near the tank or notice the pump running often, mention that too. The more precisely you describe the tank and where the sign appears, the more accurately we direct the inspection from the start.
A tank leak appears under the tank itself or on the ceiling below, and grows quickly when the tank fills. Normal damp spreads slowly and does not concentrate in one spot. The technician will clarify the difference at the first check.
Start by checking the ceiling directly under the tank, then look around the tank base on the roof. If the roof is raised, check the ceiling in the room below. Call Al Raya with a description of where the damp is and how large it is, and send a photo if you can.
Overhead tank leak detection in nearby areas
