Al Raya
Cementitious tank waterproofing in Al Badriyah District: A brush applying grey cement-based coat to a concrete tank wall

Cementitious tank waterproofing in Al Badriyah District

In Al Badriyah District, concrete water tank walls absorb water from pressure and salts from the ground. Al Raya coats the walls with a cementitious layer that penetrates the concrete and stops leaks and dampness.

What the service includes

What cementitious tank waterproofing includes

  • Checking the concrete tank walls to find cracks, pores and leak points
  • Cleaning the inner surface of dust, algae and residue from old coatings
  • Roughening the surface so the cementitious coat grips the concrete wall firmly
  • Treating fine cracks and structural joints before the waterproofing coat is applied
  • Applying the cementitious coat to the dampened wall with care at corners and edges
  • Reviewing the surfaces after application to confirm the coat covers the full wall area
How we work

From your call to a sealed wall

  1. 1

    Tell us about your tank

    Call or message us on WhatsApp, and describe the tank size, its location and what you notice: any damp or cracks in the walls.

  2. 2

    Preparing the concrete surface

    The walls are cleaned of dust, algae and old coating residue, then the surface is roughened so it takes the cementitious coat well.

  3. 3

    Treating cracks and joints

    Fine cracks and structural joints are treated first, because the waterproofing coat alone cannot close an existing crack.

  4. 4

    Applying the cementitious coat

    The cementitious material is applied to the prepared and dampened wall so it absorbs into it, and is worked again over edges and corners for full contact.

Why Al Raya

Concrete and cement work together

  • The coat bonds with the concrete tank wall
  • Works on damp walls that are hard to dry fully
  • Seals pores and penetrates the concrete from within
  • We treat cracks and joints before the coat goes on
  • We take your request by phone call or WhatsApp message
About the area

The service in Al Badriyah District

Family homes in a district like Al Badriyah usually have concrete tanks in a basement or on the roof. Salty water from local wells and constant dampness cause cracks in tank walls and gradual leaks. The team inspects the tank from outside to spot fine cracks, damp patches and salt buildup on the walls. It then cleans the wall of salt, weak material and old coatings, and applies cementitious paint in even layers that fill the concrete's pores and block water penetration.

Al Badriyah District is a district in Al-Ahsa governorate in the Eastern Province, close to Imam Muhammed Ibn Saud Islamic University District, Al Majidiyah District and Al Quds District.

Fine concrete cracks are hard to spot from inside but show from outside as damp patches or salt marks.

Read about Cementitious tank waterproofing

Our work

Our portfolio

  • Damp stains and damage on a ceiling beside a wall light
  • A hand scraping damp mortar from between small stones on a surface
  • Peeling paint on an exterior wall beside a pipe
  • Cracked and bubbling paint along a wall edge
  • A white roof with an air conditioner and satellite dishes
  • A leak detection device with headphones in a case
Reviews

What our customers say

  • ★★★★★

    شغلهم ميه ميه يشكرو عليه

  • ★★★★★

    شكرا على التواصل السريع

  • ★★★★★

    شغلهم كويس وناس ممتازه في اسرع وقت

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Cementitious tank waterproofing in Al Badriyah District

The cementitious material needs moisture in the surface to absorb into it and bond with it rather than drying out on top. If applied to a fully dry wall in the heat, the coat dries before it can penetrate the concrete and the result is weaker.

Yes, cementitious waterproofing systems are designed to resist water pressure from both sides, inside and outside. That is the main difference between a true waterproofing material and a plain cement paint. The surface must be clean and free of old coatings that block bonding.

It depends on the state of the old lining. If it is sound and not peeling it may be assessed for keeping, but if it is loose or flaking it must be removed first, because the cementitious coat needs direct contact with the concrete, not with a failing old lining.

The tank must be emptied, cleaned and prepared before waterproofing in any case. The main advantage of a cementitious material is that it works with damp concrete and does not require the complete dryness that some resin-based materials need.

Tell us whether the tank is a ground tank or an overhead tank, what you can see such as seepage in the wall, damp at the base or a peeling old coat, and whether the tank is currently in use or empty. This helps us assess what the surface needs before the cementitious coat.

The tank may not leak yet, but salt and dampness from the ground naturally enter concrete over time. Inspection shows if early signs are present: salt stains or slight damp on the outer wall.

Describe where the tank is, whether you see any damp or white marks on the outer wall, and how long water sits in it before use. Send a photo of the wall on WhatsApp if you can.

Nearby areas

Cementitious tank waterproofing in nearby areas

Sunset over villa roofs and palm trees

Call and describe your tank

WhatsApp or call us and tell us what you see on your tank walls.

Call nowWhatsApp