Al Raya
Ground tank waterproofing in Al Jishshah: The outside wall of a buried tank coated in black bitumen in an open trench

Ground tank waterproofing in Al Jishshah

Ground tank waterproofing in Al Jishshah protects the walls from cracks caused by soil and water pressure together. The work starts from the base and walls with full treatment to ensure the tank stays sound.

What the service includes

What ground tank waterproofing includes

  • Checking the tank walls, base and cold joints for cracks and weak points
  • Cleaning and preparing the internal surface before any treatment or material is applied
  • Sealing fine cracks and the cold joint between the wall and the base before waterproofing
  • Treating the internal walls with a lining that can carry the pressure of stored water
  • Treating the base and the transition zone between wall and base as a single unit
  • Assessing the external wall condition where damp soil pressure is a factor in the leak
How we work

How the work goes

  1. 1

    Tell us what you notice

    Call or message us on WhatsApp and tell us where the leak shows in the tank and whether you notice damp in the surrounding soil or a drop in the water level.

  2. 2

    Inspecting the tank and walls

    The job starts with checking the walls, the base and the cold joints for cracks and weak points before any lining is applied.

  3. 3

    Preparing the surface

    Surface preparation includes cleaning the walls and sealing cracks and any gap in the joints, because a lining is only as good as the surface it goes onto.

  4. 4

    Applying the waterproofing

    The walls and base are treated as one unit, with particular attention to the cold joint zone between the wall and the base as it is the area most exposed to leaks.

Why Al Raya

What makes this treatment reliable

  • We treat the base and walls as one unit
  • We seal cold joints before waterproofing
  • We choose a material suited to soil pressure
  • We take your request by phone call or WhatsApp message
  • Reach us by call or WhatsApp
About the area

The service in Al Jishshah

In a district like Al Jishshah, a ground tank is buried under the house or yard, so it faces soil moisture and groundwater from outside and water pressure from inside. Treatment starts with cleaning the surface and repairing cracks and joints in the walls and base, then waterproof layers of epoxy or bitumen are applied to stop seepage. Tank joints and corners need special care because they are the weakest points. The existing tank is checked first to see how much damage there is and what steps are needed.

Al Jishshah is a district in Al-Ahsa governorate in the Eastern Province, close to Al Markaz, Al Jafr and As Sabat.

In ground tanks, groundwater and damp soil press on the outer walls while stored water presses from inside.

Read about Ground tank waterproofing

Our work

Our portfolio

  • The edge of a roof insulated in white beside a building under a clear sky
  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A hole in a broken wall exposing pipes and wires
  • Two workers on a large roof insulated in white
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
Reviews

What our customers say

  • ★★★★★

    شكراً لخدمتك الجميلة

  • ★★★★★

    شكرا على التواصل وصلو في اسرع وقت ممكن

  • ★★★★★

    شكرا على التواصل السريع

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Ground tank waterproofing in Al Jishshah

A ground tank carries the pressure of damp soil on its outer walls, which an overhead tank does not. So the walls need a treatment that can handle that additional pressure, and the cold joint between the wall and the base is more prone to cracking under these conditions.

The base receives the pressure of the stored water from above and that of damp or groundwater from below. The cold joint between the base pour and the wall pour is usually the first place a leak appears, because that joint is weaker than solid homogeneous concrete.

An internal lining protects water from escaping and treats the wall surface from inside. But if damp soil pressure is pushing water from outside in, the wall may also need external treatment. What suits each tank depends on the actual condition and position of the leak.

A fine crack in concrete does not let water through freely at first, but it widens with repeated filling and emptying as the concrete expands and contracts. When the crack reaches enough depth it becomes a direct path for water. That is why cracks are treated before the waterproofing layer, not after.

Tell us whether the tank is fully buried, partly buried or at ground level, where the leak shows such as the walls, the base or the cold joint between them, and whether you notice damp in the surrounding soil or a drop in the water level inside. These details help us identify the right treatment.

If you see seepage from the tank walls or damp patches around it under the yard, or if water levels drop without clear reason, the tank needs checking and waterproofing.

No, the tank is treated in place underground. The inner and outer surfaces are cleaned, cracks and joints are repaired, then waterproof layers are applied, all without taking the tank apart.

Nearby areas

Ground tank waterproofing in nearby areas

Sunset over villa roofs and palm trees

Call and describe your tank

Call or WhatsApp us and tell us what you notice in your ground tank.

Call nowWhatsApp