Al Raya
Ground tank waterproofing in Al Wurud 3rd District: The outside wall of a buried tank coated in black bitumen in an open trench

Ground tank waterproofing in Al Wurud 3rd District

Ground tank waterproofing in Al Wurud 3rd District is essential to prevent water and dampness seeping into the house below. Al Raya treats the tank walls and base with barriers against soil pressure and water pressure together.

What the service includes

What ground tank waterproofing includes

  • Checking the tank walls, base and cold joints for cracks and weak points
  • Cleaning and preparing the internal surface before any treatment or material is applied
  • Sealing fine cracks and the cold joint between the wall and the base before waterproofing
  • Treating the internal walls with a lining that can carry the pressure of stored water
  • Treating the base and the transition zone between wall and base as a single unit
  • Assessing the external wall condition where damp soil pressure is a factor in the leak
How we work

How the work goes

  1. 1

    Tell us what you notice

    Call or message us on WhatsApp and tell us where the leak shows in the tank and whether you notice damp in the surrounding soil or a drop in the water level.

  2. 2

    Inspecting the tank and walls

    The job starts with checking the walls, the base and the cold joints for cracks and weak points before any lining is applied.

  3. 3

    Preparing the surface

    Surface preparation includes cleaning the walls and sealing cracks and any gap in the joints, because a lining is only as good as the surface it goes onto.

  4. 4

    Applying the waterproofing

    The walls and base are treated as one unit, with particular attention to the cold joint zone between the wall and the base as it is the area most exposed to leaks.

Why Al Raya

What makes this treatment reliable

  • We treat the base and walls as one unit
  • We seal cold joints before waterproofing
  • We choose a material suited to soil pressure
  • We take your request by phone call or WhatsApp message
  • Reach us by call or WhatsApp
About the area

The service in Al Wurud 3rd District

In a district like Al Wurud 3rd, ground tanks sit beneath or beside the foundation, and soil pressure around them adds load to the walls with water pressure from inside. Cracks usually appear at corners, construction joints and the base, and they are paths for dampness and salty groundwater to enter. Al Raya inspects the concrete quality and base first, then cleans and prepares the inner and outer surfaces, fills the cracks, and applies layers of waterproof and thermal barriers. Inspection determines whether protection needs sprayed foam, bitumen sheets or both.

Al Wurud 3rd District is a residential area in Al-Ahsa governorate in the Eastern Province, close to As Suqur District, Al Hada District and Al Matar District.

Construction joints in a ground tank are the first weak points, where concrete shifts under pressure.

Read about Ground tank waterproofing

Our work

Our portfolio

  • The edge of a roof insulated in white beside a building under a clear sky
  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A hole in a broken wall exposing pipes and wires
  • Two workers on a large roof insulated in white
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
Reviews

What our customers say

  • ★★★★★

    شكراً لخدمتك الجميلة

  • ★★★★★

    شكرا على التواصل وصلو في اسرع وقت ممكن

  • ★★★★★

    شكرا على التواصل السريع

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Ground tank waterproofing in Al Wurud 3rd District

A ground tank carries the pressure of damp soil on its outer walls, which an overhead tank does not. So the walls need a treatment that can handle that additional pressure, and the cold joint between the wall and the base is more prone to cracking under these conditions.

The base receives the pressure of the stored water from above and that of damp or groundwater from below. The cold joint between the base pour and the wall pour is usually the first place a leak appears, because that joint is weaker than solid homogeneous concrete.

An internal lining protects water from escaping and treats the wall surface from inside. But if damp soil pressure is pushing water from outside in, the wall may also need external treatment. What suits each tank depends on the actual condition and position of the leak.

A fine crack in concrete does not let water through freely at first, but it widens with repeated filling and emptying as the concrete expands and contracts. When the crack reaches enough depth it becomes a direct path for water. That is why cracks are treated before the waterproofing layer, not after.

Tell us whether the tank is fully buried, partly buried or at ground level, where the leak shows such as the walls, the base or the cold joint between them, and whether you notice damp in the surrounding soil or a drop in the water level inside. These details help us identify the right treatment.

Watch the foundation and lower surfaces beside and under the tank. Look for persistent damp patches or pooling water, old damp smells, or cracked plaster on the adjoining walls.

Tell him whether the tank is under or beside the house, how long you have noticed dampness, and whether there is cracking in the concrete or foundation. Send photos of the floor and adjoining walls on WhatsApp.

Sunset over villa roofs and palm trees

Call and describe your tank

Call or WhatsApp us and tell us what you notice in your ground tank.

Call nowWhatsApp