Al Raya
Tanks & roofs together in Haradh: A roof and the base of its water tank both freshly coated in white waterproofing

Tanks & roofs together in Haradh

In Haradh, roof tanks are part of everyday life, but a leaking tank into the roof and house is inevitable unless it is fixed. Al Raya treats the tank and roof together with thorough inspection and strong waterproofing materials.

What the service includes

What this service includes

  • Checking the roof slab, joints, drains and parapet before starting
  • Treating cracks, edges and joints in the roof before the waterproofing is applied
  • Waterproofing the full roof area including the zone around the tank base
  • Waterproofing the tank base and outer walls on top of the finished roof
  • Adding thermal insulation with polyurethane foam on the roof where needed
  • Treating the shared weak points between the tank and the roof in a single job
How we work

From your call to the finished job

  1. 1

    Describe what you see

    Call or message us on WhatsApp and tell us whether the damp shows on the roof, below it, around the tank, or in all of these places.

  2. 2

    We inspect the roof and the tank together

    We check the condition of the roof slab, the joints, the edges and the parapet, then the tank base and its outer walls, because each affects the other.

  3. 3

    We waterproof the roof first

    The roof slab is prepared and the cracks, joints and drains are treated, then the waterproofing layer is applied across the full area including the zone around the tank base.

  4. 4

    We treat the tank on a finished roof

    Once the roof is ready we waterproof the tank base and its outer walls, so both layers work together and neither undoes what the other seals.

Why Al Raya

One treatment instead of two

  • The tank and the roof are treated together in one complete job
  • The order of the work stops one waterproofing layer from damaging the other
  • We waterproof and thermally insulate according to each surface's condition
  • We take your request by phone call or WhatsApp message
  • Cost depends on the case, message us to work it out together
About the area

The service in Haradh

The town depends on overhead water tanks, and they are prone to leaking from pressure, heat and damp. Water may seep from the tank base, walls, joints around it, or pipes. When a leak occurs, it wets the roof and then penetrates the ceiling and walls, especially in Al-Ahsa where salt and natural moisture are present. Checking the tank on all sides is the first step, then treating its base, walls and joints with strong materials, then insulating the roof with one continuous layer of foam or bitumen. This stops the leak at the source and protects the house from damp and heat.

Haradh is a town in Al-Ahsa governorate in the Eastern Province, close to Ash Shuruq, Al Ekhaa and Ar Rabie.

The constant pressure of water weight in the tank weakens joints and the base over time, making leaks inevitable.

Read about Tanks & roofs together

Our work

Our portfolio

  • A hole in a broken wall exposing pipes and wires
  • Two workers on a large roof insulated in white
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
  • A building roof covered in white insulation
  • A roof covered in white insulation with a worker in the distance
Reviews

What our customers say

  • ★★★★★

    شركه ممتازه واشتغلنا معاهم اكثر من مره وجود عاليه ما شاء الله بارك الله فيهم واعمله

  • ★★★★★

    شركه ممتاز شغلهم كويس ويعطيهم العافيه

  • ★★★★★

    شركه ممتازه

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Tanks & roofs together in Haradh

Yes, if the roof slab is sound and the joints and drains are tight, treating the tank alone is enough. But if the roof has cracks or signs of damp, ignoring it means water will find a way through even after the tank is sealed. That is why we check both before deciding.

They suit the roof's condition and what it needs. Bitumen rolls are laid over open areas and the edges and joints are sealed. Epoxy suits the finish around the tank base and at the drains. Polyurethane foam may be added for thermal insulation where the roof is exposed to direct sun.

The tank base sits directly on the roof slab, and any water that leaks from under the tank stops only where the waterproofing ends. If the slab is bare or has an old worn layer, the water soaks into it and reaches the floor below. Over time the slab itself cracks under the accumulated moisture.

If the stain is concentrated directly below the tank, the tank is likely the cause. If it spreads across a wider area of the ceiling, the roof is the more likely source. But the two often work together to bring water to the same place, so inspection alone tells them apart with certainty.

Tell us whether the damp appears on the top-floor ceiling, on the roof surface around the tank, or both. Tell us whether the tank is concrete or fibreglass and whether water appears under its base. These details tell us where to start and which materials suit the situation.

If you fix the tank alone, water may leak from another place you did not see. If you seal the roof alone, water enters from under the tank. Treating both together means a complete check of the tank first, then full roof insulation. This ensures no weak spot is left.

Tell them exactly where you see water dripping, from roof or ceiling, whether the roof has cracks or damp patches, and the tank's condition outside. Send photos of the tank, roof and ceiling from inside the house on WhatsApp.

Nearby areas

Tanks & roofs together in nearby areas

Sunset over villa roofs and palm trees

Call and we start at the source

Message us on WhatsApp and describe the tank, the roof and what you see.

Call nowWhatsApp