
What bathroom waterproofing after tiling includes
- Inspecting the joints between tiles and the corners at the wall base to find where water enters
- Checking the openings where drain and water pipes pass through the floor or wall
- Assessing whether treatment is possible without lifting tiles or requires it
- Preparing the surface by removing worn and loose material before any treatment is applied
- Treating the joints, corners and openings with the material suited to each, such as epoxy or a flexible sealant
- Sealing the corners with a flexible material that absorbs movement and prevents water re-entering
From your call to the treatment
- 1
Tell us what you see
Call or message us on WhatsApp and describe the stain, where it is, and whether it appears only after the bathroom is used or all the time.
- 2
We inspect the entry point
We check the joints between tiles, the corners at the floor and wall, the drain opening and the pipe entries to find where the water is getting in.
- 3
We assess what can be treated without lifting tiles
When the damage is limited to joints, openings and corners, these can be treated directly. If the layer under the tiles has failed widely, lifting the tiles becomes necessary to lay a new layer.
- 4
We treat and seal
We treat the joints, openings and corners with the material suited to each, and surfaces are prepared before any treatment, because working on a dirty or loose surface produces no real result.
The problem can be treated
- We find the water source before any work
- We treat joints, corners and openings
- We inspect the floor, walls and drain
- We use epoxy and appropriate materials
- We take your request by phone call or WhatsApp message
The service in Al Badriyah District
Bathrooms in homes in the district are prone to leaks because water reaches the joints between tiles and finds fine cracks in mortar and the substrate. The leak often starts at the bathroom floor, around pipes or below the siphon, and may take time before damage shows below. Work begins with pinpointing where water enters by checking the bathroom and ceiling carefully, then the area is treated with waterproofing that covers cracks and joints and keeps water from staying in the structure.
Al Badriyah District is a district in Al-Ahsa governorate in the Eastern Province, close to Imam Muhammed Ibn Saud Islamic University District, Al Majidiyah District and Al Quds District.
The first check determines whether the leak comes from under the tiles, from pipes, or from below the bathroom substrate.
Our portfolio
What our customers say
- ★★★★★
شركة ممتازة تستحق التعامل معها بشكل مستمر
- ★★★★★
شكراً لخدمتك الجميلة
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Bathroom waterproofing after tiling in Al Badriyah District
Treating the joints means removing worn grout, refilling the joints and sealing the corners and openings. It suits cases where the damage is limited to those areas. Full re-waterproofing means lifting the tiles and laying a new layer, and is only needed when the original layer has failed across a wide area or was never there.
In some cases it is possible to reach the joints or cracks from the other side, that is from the ceiling or wall below or beside the bathroom, and inject a sealing material from there. Whether this is suitable depends on where the water enters and how wide the damage is, and it does not suit every case.
Epoxy is a resin that hardens into a solid water-resistant layer, and it is used to fill joints, seal openings and corners. It needs a clean, dry and sound surface before it is applied. If the tiles are poorly bonded or the floor beneath them is crumbling, epoxy alone is not enough and lifting the tiles may be necessary.
The corner between the floor and the wall is the area most exposed to structural movement and to pooling water. Even when a waterproof layer is laid before tiling, the corner needs an additional seal with a strip or a flexible material that absorbs movement. When tiles are laid directly without a layer or without sealing the corner, this becomes the first point where water enters.
If the damp appears in a specific spot tied to a joint, corner or opening, and the tiles are firm and the floor beneath them is sound, treating the joints directly is a reasonable option. But if stains appear across wide areas that do not match any particular joint, or if tiles are hollow or moving, the layer beneath them has likely failed across an area that sealing joints alone cannot fix. An inspection is what determines this accurately.
If the stain is directly below the bathroom or near pipes running from it, and it grows after using the bathroom, the leak is from the bathroom. Call for a close check to find exactly where water enters.
Tell where the damp patch is exactly and whether it is directly below the bathroom or away from it, whether water appeared after recent work or has been there for a while, and send a photo of the patch on WhatsApp.
Bathroom waterproofing after tiling in nearby areas



















