What bitumen bathroom waterproofing includes
- Assessing the condition of the bathroom floor and wall bases before any work begins
- Treating cracks and loose sections in the surface so the base is sound
- Laying the bitumen roll or brushing the bitumen coating over the full floor area
- Turning the layer up the wall bases to a height that covers the wet zone
- Treating the corners and drain joints carefully as the most vulnerable points
- Checking the layer after application to make sure there are no gaps or uncovered areas
From your call to the finished layer
- 1
Tell us the situation
Call or WhatsApp us and tell us whether the bathroom is under construction or finished, and whether the tiles are already in place.
- 2
Surface preparation
Before any material is laid, the floor must be clean, dry and free of cracks or loose sections, because any flaw under the layer weakens how well it holds.
- 3
Laying the bitumen layer
The roll is bonded or the coating is brushed over the full floor area and turned up at the wall bases. The corners and the joints around the drain are treated carefully, as these are usually the most vulnerable points.
- 4
Protecting the layer before tiling
Once the layer is ready it is left to settle, then work continues over it. Any hole or damage in it before tiling is in place will cancel its purpose entirely.
The bitumen layer is worth getting right
- Bitumen is an established material for waterproofing wet surfaces
- The roll covers the full floor without gaps when bonded correctly
- The coating reaches corners and irregular shapes easily
- Drain joints and wall bases are treated as part of the same job
- We take your request by phone call or WhatsApp message
The service in Haradh
In a town like Haradh where homes vary between ground floors and upper storeys, bathrooms can be in different locations and each needs water protection. Constant moisture weakens concrete and walls, and in Al-Ahsa where dampness and salts are common, deterioration is faster. Al Raya checks the floor and walls for cracks, weak joints and any old dampness or salt staining, then cleans the surface thoroughly and prepares it to receive bitumen in one continuous layer covering the floor, walls to sufficient height and all corners. The initial check shows whether seepage is recent or has built up over years.
Haradh is a town in Al-Ahsa governorate in the Eastern Province, close to Ash Shuruq, Al Ekhaa and Ar Rabie.
The initial check focuses on the joint between wall and floor and around pipes, because water enters there before the middle of the floor.
Our portfolio
What our customers say
- ★★★★★
شركه ممتازه
- ★★★★★
شكرا على التواصل السريع
- ★★★★★
شركه ممتازه واشتغلنا معاهم اكثر من مره وجود عاليه ما شاء الله بارك الله فيهم واعمله
Reviews are shown as the customers wrote them, in Arabic.
Questions about Bitumen bathroom waterproofing in Haradh
The roll is a ready-made membrane cut to size and bonded to the surface with heat or adhesive; it suits flat, open floors. The coating is a liquid brushed on that reaches corners, irregular shapes and drain openings easily. The choice between them depends on the condition of the surface and the shape of the area to be waterproofed.
Bitumen is normally used on the floor and on the wall bases to a useful height above floor level, covering the area most exposed to water. The full walls around a shower area may call for a different waterproofing material better suited to a vertical surface and the way tiles are fixed above it.
No. The roll needs a clean, dry surface free of loose sections or cracks, otherwise it will not bond correctly and water will find its way under it. If the floor is already tiled, whether it is a suitable base needs to be assessed before work begins.
Because these areas have joints and changes in surface direction, and they are where water finds a path faster than anywhere else. A flat roll is hard to lay without gaps at a corner or around a drain edge, so these points usually need extra treatment with a coating or reinforcing strips before the main roll goes down.
Tell us whether the bathroom is under construction or finished, whether the tiles are in place, and where damp shows if it is visible. If you know what earlier work was done on the floor, that helps us assess the situation. The more clearly you describe it, the better we can judge what is needed.
Bitumen stops water entering, which reduces salts dissolved in water from getting in. But if salts are already in the walls or foundations, new waterproofing prevents more but does not remove what is old.
Say when dampness started to appear, whether you see black stains or white salt on walls, whether water leaks from below or from the sides, and send a photo of the affected area on WhatsApp.
More services in Haradh
Bitumen bathroom waterproofing in nearby areas
