Al Raya
Cementitious waterproofing in At Tuhaymiyah: A brush spreading grey cement-based slurry on a concrete wall

Cementitious waterproofing in At Tuhaymiyah

Cementitious waterproofing in At Tuhaymiyah stops water seeping through house walls and tanks with a thick coat that seals the pores from inside. In this small settlement, where groundwater and damp are common, cementitious protection saves lower walls and tanks from damage.

What the service includes

What cementitious waterproofing includes

  • Assessing the concrete surface and the state of any existing coating before starting
  • Removing loose sections and cleaning the surface in preparation for application
  • Treating surface cracks in the concrete before the slurry goes on
  • Mixing the cementitious material and applying it to walls, floors or the tank
  • Extra care at joints and corners as these are the most common entry points for water
  • Checking the surface after application to confirm coverage of critical areas
How we work

From your call to the finished coat

  1. 1

    Describe what you see

    Call or message us on WhatsApp and tell us where the damp is: a wall, a tank, a wet room or elsewhere, and what you notice on the surface.

  2. 2

    Preparing the surface

    The job starts with cleaning the concrete, removing loose sections and surface cracks so the slurry bonds to a solid base.

  3. 3

    Mixing and applying the slurry

    The powder is mixed with water to an even consistency, then brushed or sprayed onto the surface so it penetrates into the pores.

  4. 4

    Treating joints and corners

    The joints between the wall and the floor and the corners of a tank are where water usually enters first, so they receive extra attention during application.

Why Al Raya

Why it suits these surfaces and tanks

  • Penetrates concrete pores and bonds to them
  • Safe for use in water tanks
  • Suits walls, wet rooms and concrete surfaces
  • Handles water pressure from inside and outside
  • We take your request by phone call or WhatsApp message
About the area

The service in At Tuhaymiyah

In homes and settlements like At Tuhaymiyah, lower walls often suffer damp and salt damage from groundwater and ground moisture, and owners may see damp patches, wall cracks or a leaking water tank. The cementitious coat is applied straight to the concrete surface after cleaning and preparation, filling the pores to form a water barrier. Before coating, the leak and crack positions are checked, because deep cracks may need treatment first.

At Tuhaymiyah is a small settlement in Al-Ahsa governorate in the Eastern Province, close to Al 'Uthmaniyah, Udhailiyah and Imam Muhammed Ibn Saud Islamic University District.

Lower walls and tanks are the first to absorb moisture from the soil, and the initial check shows whether the leak comes from within the concrete or from its surface.

Read about Cementitious waterproofing

Our work

Our portfolio

  • A worker rolling white insulation coating onto a villa roof
  • A white roof with an air conditioner and satellite dishes
  • The edge of a roof insulated in white beside a building under a clear sky
  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
Reviews

What our customers say

  • ★★★★★

    شركه ممتازه واشتغلنا معاهم اكثر من مره وجود عاليه ما شاء الله بارك الله فيهم واعمله

  • ★★★★★

    شركه ممتازه

  • ★★★★★

    ممتاز والخدمة ان شاء الله تكون قد التوقعات

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Cementitious waterproofing in At Tuhaymiyah

It goes on concrete, cement render, brick and block. It works well on stable surfaces that do not move or flex, such as tank walls, wet room floors and flat concrete roofs. It does not suit surfaces subject to ongoing movement or wide expansion joints.

Cementitious coating penetrates and bonds inside the concrete pores rather than forming a separate sheet on top. Bitumen rolls and plastic membranes form a separate layer above the surface. So the cementitious option is chosen when the surface is stable concrete with no expected movement.

Yes, it is used in water tanks because the cementitious material is naturally compatible with concrete and does not release harmful substances after it cures. However, any loose old coating must be removed and the surface cleaned well before application so the slurry bonds directly to sound concrete.

The floor and wall meet at a joint that is usually the first weak point. Water collects at that joint, enters the concrete and then rises by capillary action. That is why corners and joints receive special attention when cementitious waterproofing is applied in wet rooms.

Tell us where the damp is: a bathroom, a tank or an internal wall. Tell us whether it appears after use or all the time, and whether there is peeling paint or salt deposits on the surface. The clearer your description, the easier it is for us to assess the surface condition before we visit.

If you see damp patches or discolouration on a lower wall, feel moisture at the wall, or notice peeling paint or a musty smell, these show that water is entering from the soil. Call Al Raya to inspect the spot and confirm the cause.

Yes, cementitious waterproofing is applied to new and old concrete tanks to stop water leaks. If the tank leaks from inside or outside, it is checked first to find the leak and cracks before coating.

Nearby areas

Cementitious waterproofing in nearby areas

Sunset over villa roofs and palm trees

Tell us what you see

Call or WhatsApp us and describe the wall or tank giving you trouble.

Call nowWhatsApp