What plaster crack repair includes
- Checking the plaster layer by tapping and direct inspection to find hollow sections and areas that have separated
- Identifying why it cracked: drying too fast, the mix ratio or poor bonding to the surface behind it
- Removing the hollow and cracked plaster and cleaning the base surface ready for repair
- Re-plastering the treated areas to suit the wall type and the required finish
- Treating fine surface cracks where the layer behind them is sound and properly bonded
- Answering your questions about plaster crack repair before the work starts
From your call to a sound wall
- 1
Describe what you see
Call or message us on WhatsApp, and tell us where the cracks are, what they look like, and whether the wall sounds hollow when you tap it.
- 2
Inspect and diagnose the layer
We check the plaster by tapping and direct inspection to find where the layer is hollow or has separated from the surface behind it, and to identify the cause of the cracking.
- 3
Remove the weak areas
The damaged and hollow plaster is cut out fully until the base surface is exposed, because filling cracks over a loose layer does not hold the finish.
- 4
Re-plaster onto the prepared surface
After the surface is ready, the treated areas are re-plastered to suit the wall type and the required finish so they blend with the surrounding surface.
The wall becomes sound again
- We tell a plaster crack from a crack in the wall behind it
- We find hidden hollow sections by direct inspection
- We remove the weak layer before any repair
- We re-plaster onto a properly prepared surface
- We take your request by phone call or WhatsApp message
The service in Ibn Dihman
In a small settlement like Ibn Dihman, homes are close together and often share similar problems because of ground and climate. Plaster cracks are common and have multiple causes: fast drying in summer heat, natural wall movement as it settles, or rising damp and salts from wet ground. The team inspects cracks carefully, taps the wall to see if plaster is detached, and looks for damp signs. Then it decides whether surface repair is enough or whether damp treatment is needed first.
Ibn Dihman is a small settlement in Al-Ahsa governorate in the Eastern Province, close to Muraytibah, Sudah and Al Jishshah.
In small settlements, cracks in lower-storey walls often signal rising damp from soil, and this must be treated before plaster repair.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شغلهم كويس وناس ممتازه في اسرع وقت
- ★★★★★
شغلهم ميه ميه يشكرو عليه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Plaster crack repair in Ibn Dihman
A network of fine surface cracks that looks like a map usually stays in the plaster layer alone. A single wide crack that extends and widens over time often reaches the wall behind it. Tapping with a knuckle helps: a hollow sound means the layer has separated from what is behind it.
The common cause is drying too fast, particularly in hot dry weather. The mix ratio of water or sand, a dry surface that was not wetted before application, or applying too thick a layer without waiting can all be causes. These factors affect how the layer holds even if the wall looks sound at first.
If the plaster behind the cracks is properly bonded and there is no hollow section, filling fine cracks with a flexible material before painting may be enough. But if the layer is hollow under the surface, any finish above it is temporary, because the layer will eventually come away and take the finish with it.
Yes. The job starts by identifying the hollow or cracked areas precisely, then those areas are removed and replaced without disturbing the sound plaster around them. The aim is to remove what is actually weak, nothing more. The area to be removed is determined after inspection, not before.
Tell us where in the house the cracks are, whether they look like a fine network or a single extending crack, whether the wall sounds hollow when tapped, and whether there is any damp or peeling alongside them. These details help us decide what needs to be checked first.
If cracks return quickly, the cause is usually not the plaster alone but the wall or rising damp from the ground. Surface repair will not last if the wall moves or damp continues, so the real cause must be found first.
Say when the cracks began to appear, whether they are in lower or upper walls, and whether walls are damp or show salt stains or an odd smell. Send photos of the cracks and surrounding walls on WhatsApp, as this helps with initial diagnosis.
