What plaster crack repair includes
- Checking the plaster layer by tapping and direct inspection to find hollow sections and areas that have separated
- Identifying why it cracked: drying too fast, the mix ratio or poor bonding to the surface behind it
- Removing the hollow and cracked plaster and cleaning the base surface ready for repair
- Re-plastering the treated areas to suit the wall type and the required finish
- Treating fine surface cracks where the layer behind them is sound and properly bonded
- Answering your questions about plaster crack repair before the work starts
From your call to a sound wall
- 1
Describe what you see
Call or message us on WhatsApp, and tell us where the cracks are, what they look like, and whether the wall sounds hollow when you tap it.
- 2
Inspect and diagnose the layer
We check the plaster by tapping and direct inspection to find where the layer is hollow or has separated from the surface behind it, and to identify the cause of the cracking.
- 3
Remove the weak areas
The damaged and hollow plaster is cut out fully until the base surface is exposed, because filling cracks over a loose layer does not hold the finish.
- 4
Re-plaster onto the prepared surface
After the surface is ready, the treated areas are re-plastered to suit the wall type and the required finish so they blend with the surrounding surface.
The wall becomes sound again
- We tell a plaster crack from a crack in the wall behind it
- We find hidden hollow sections by direct inspection
- We remove the weak layer before any repair
- We re-plaster onto a properly prepared surface
- We take your request by phone call or WhatsApp message
The service in Muraytibah
In a small settlement like Muraytibah, home walls face rising damp from the soil and exposure to the elements. Problems often start as small cracks in plaster or hollow pockets that sound empty when tapped, and may be joined by damp patches or surface discoloration. The first inspection decides whether plaster alone is the problem or the wall behind it needs other work. Because damp and salts in Al-Ahsa speed up plaster decay, the surface must be cleaned and cracks and joints treated with care.
Muraytibah is a small settlement in Al-Ahsa governorate in the Eastern Province, close to Sudah, Al Ghuwaybah and At Taraf.
Rising damp from the ground affects lower walls first, where cracks, hollow spots and patches appear.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شغلهم كويس وناس ممتازه في اسرع وقت
- ★★★★★
شغلهم ميه ميه يشكرو عليه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Plaster crack repair in Muraytibah
A network of fine surface cracks that looks like a map usually stays in the plaster layer alone. A single wide crack that extends and widens over time often reaches the wall behind it. Tapping with a knuckle helps: a hollow sound means the layer has separated from what is behind it.
The common cause is drying too fast, particularly in hot dry weather. The mix ratio of water or sand, a dry surface that was not wetted before application, or applying too thick a layer without waiting can all be causes. These factors affect how the layer holds even if the wall looks sound at first.
If the plaster behind the cracks is properly bonded and there is no hollow section, filling fine cracks with a flexible material before painting may be enough. But if the layer is hollow under the surface, any finish above it is temporary, because the layer will eventually come away and take the finish with it.
Yes. The job starts by identifying the hollow or cracked areas precisely, then those areas are removed and replaced without disturbing the sound plaster around them. The aim is to remove what is actually weak, nothing more. The area to be removed is determined after inspection, not before.
Tell us where in the house the cracks are, whether they look like a fine network or a single extending crack, whether the wall sounds hollow when tapped, and whether there is any damp or peeling alongside them. These details help us decide what needs to be checked first.
Surface plaster cracks appear as fine lines and may sound hollow when pressed. Wall cracks are deeper and wider and may grow over time. The initial inspection shows the difference clearly.
Look for dark patches or color change in plaster, or a musty smell, or cracks with visible damp. These signs show that damp is rising from the soil and deserves a close inspection.
