From your call to treating the tank
- 1
Tell us what you see
Call or message us on WhatsApp and tell us the type of tank, where the damp appears or where the water level drops.
- 2
We inspect the tank
We check the walls, the base, the joints and the existing lining to find where water enters and what damage has been caused.
- 3
We prepare the surface and treat cracks
The tank is fully emptied and cleaned, and cracks and joints are treated before any lining work, because a lining cannot do its job over an unprepared surface.
- 4
We apply the right waterproofing
We choose the lining system that suits the tank type and the condition we find, and apply it to the walls and base together until the treatment is complete.
The tank can be fixed with the right waterproofing
- We treat ground tanks and overhead concrete tanks
- We apply an epoxy lining or a cementitious coat as the case requires
- We treat cracks and joints before the waterproofing, not after
- We take your request by phone call or WhatsApp message
- Walls and base waterproofed in a single job
The service in Al Olaya District
In districts like Al Olaya, tanks usually sit on roofs or are buried in foundations, and water leaks through cracked walls or where the base meets the ground. The salty groundwater in Al-Ahsa speeds up tank wall decay and increases dampness. The first check reveals exactly where the water is coming from, then the tank surfaces are prepared, cracks and joints are cleaned, and waterproofing material is applied to all damaged areas.
Al Olaya District is a district in Al-Ahsa governorate in the Eastern Province, close to Al Uwaimiriyah District, Al Thulaythiyah District and Ar Rawdah District.
Cracks in the base from summer heat and salty groundwater are most likely to cause rapid leaking and ongoing dampness.
Our portfolio
What our customers say
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شغلهم نظيف وسريعين ومحترمين الله يعطيهم العافيه
- ★★★★★
شركه ممتازه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Water tank waterproofing in Al Olaya District
Inside waterproofing treats the surface that is in direct contact with the water, and it is the most effective way to stop a leak because the lining faces the pressure from the right direction. Outside waterproofing is used when the tank wall is buried or faces soil moisture, and ground tanks are often treated on both sides.
Yes, considerably. A concrete tank has a rigid wall where cracks and joints accumulate over time, and it suits cementitious or epoxy linings designed to bond with concrete. A fibreglass tank has a flexible wall that cracks differently, and needs a resin repair that is compatible with its material.
Before, always. A crack in the tank wall is a direct path for water, and any lining applied over it without prior repair will separate from it or crack with it in time. Repairing the crack first is what allows the lining to do its job.
The base carries the full weight of the water above it, and the joint between the base and the wall is often a structural weak point formed during casting. Moisture also collects in the lower corners and presses on any crack or porous area in the concrete. That is why the wall and the base are waterproofed together, not separately.
It depends on the condition of the tank and the type of surface. Epoxy forms a smooth, fully sealed film that resists moisture, and it works well when the surface is level and ready to bond. A cementitious coat bonds deep into the concrete and suits rough surfaces or those that need levelling first. We decide which is right after inspecting the tank.
Yes, emptying is a basic requirement. No surface can be prepared and no lining applied on a wet wall or under water. The tank is fully emptied and cleaned until the surface is dry and ready to receive the waterproofing material. Tell us the size and location of the tank and we will work out the details with you.
Tell us the type of tank, ground or overhead, whether it is concrete or fibreglass, where the leak sign appears and whether the water level has dropped or damp shows on the outer wall. The clearer your description, the more directly we can point you to the right service.
We check the tank first to find how many cracks it has and where they are, then we carefully prepare the surface and apply waterproofing material to every crack and joint, because each tank needs different treatment.
Yes, we check the buried tank inside and out if we can reach it, and treat leaks from its walls and base, but access and a thorough check determine what can be treated.
More services in Al Olaya District
