What epoxy tank lining includes
- Checking the inner walls and base to identify cracks and damaged areas before starting
- Emptying the tank and removing sediment and flaking old layers from the entire inner surface
- Treating cracks and joints in the walls and base before the epoxy coat is applied
- Verifying the surface is dry and even before coating so the layer bonds properly
- Applying epoxy to the inner walls and base so it hardens into a smooth, continuous film
- Reviewing the finished layer after hardening and confirming it covers the entire inner surface
From your message to a finished lining
- 1
Describe your tank
Call or message us on WhatsApp and tell us the type of tank, where it sits, and what you notice inside or around it, whether damp marks or cracks.
- 2
Emptying and cleaning
The tank is fully emptied and any sediment or flaking old layers are removed from the walls, because epoxy will not bond to a dirty or loose surface.
- 3
Repairing cracks and preparing the surface
Cracks and joints are repaired before coating, and the surface is checked to be dry and even, because the epoxy layer is only as good as the surface beneath it.
- 4
Applying the epoxy
The epoxy is applied to the inner walls and the base and hardens into a smooth, continuous film that seals the pores and separates the surface from the water.
The tank will be sealed from inside
- Epoxy seals the concrete pores and smooths the surface
- A smooth surface stops sediment sticking to the walls
- We treat cracks before coating, not over them
- Suitable for ground tanks and overhead tanks alike
- We take your request by phone call or WhatsApp message
The service in Mansubi Al Taleem 2nd District
Tanks in homes in a district like Mansubi Al Taleem 2nd District are exposed to damp from soil and mineral salts across Al-Ahsa, especially near foundations and drains. Old or damaged tank walls let damp and salts enter and change water quality. Inspection starts with viewing the walls inside and identifying cracks, damp, sediment and stains, then the tank is cleaned carefully and the walls are dried fully. Epoxy is then applied to a clean, dry surface, forming a barrier that seals the walls from the water.
Mansubi Al Taleem 2nd District is a district in Al-Ahsa governorate in the Eastern Province, close to Sports City, Al Danah District and Mansubi Al Taleem 1st District.
The tank's inner walls are checked first, because cracks, damp and sediment show whether epoxy is needed.
Our portfolio
What our customers say
- ★★★★★
شكرا على التواصل السريع
- ★★★★★
شكراً لخدمتك الجميلة
- ★★★★★
شغلهم نظيف وسريعين ومحترمين الله يعطيهم العافيه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Epoxy tank lining in Mansubi Al Taleem 2nd District
Yes, the base is part of the inner surface and it cannot be left untreated while the walls are coated. Water sits on the base and presses into its pores, and a continuous lining stops a leak wherever it tries to get through.
Ordinary paint is a surface coat that peels with constant water contact and does not seal the concrete pores. Epoxy is a resin that reacts, hardens and bonds to the surface, forming a solid film that actually separates the concrete from the water and does not break down easily.
Epoxy bonds to a range of surfaces and is used in concrete, metal and other tanks when the surface is prepared, clean and dry. What changes is how the surface is prepared according to the material, not the principle of applying the coat.
Epoxy bonds to a solid surface, not to water sitting in the concrete pores. If the surface is damp, a gap forms between the coat and the wall that weakens adhesion and leaves the lining prone to blistering and peeling later. Dryness is a requirement, not a precaution.
Yes, the size of the tank does not change how the work is done. Small roof tanks go through daily temperature swings that stress the walls and open fine pores and cracks. An epoxy lining on the inner walls seals those pores and protects the surface whatever the size of the tank.
Warning signs are brown or white stains on the inner walls, odd smell or taste in the water, or visible damp. Open the tank lid and look inside, or send a photo on WhatsApp to identify the state.
Epoxy hardens over the walls and does not dissolve in water, so it does not change its colour or taste. In fact, it stops sediment and salts from the walls entering the water, so the water may become cleaner than before.
More services in Mansubi Al Taleem 2nd District
Epoxy tank lining in nearby areas
