Al Raya
Ground tank waterproofing in Ash Shi’bah: The outside wall of a buried tank coated in black bitumen in an open trench

Ground tank waterproofing in Ash Shi’bah

Ground tank waterproofing in Ash Shi'bah protects the foundation and walls from water and damp soil. Al Raya treats the tank base and walls with continuous waterproof layers to stop leaks.

What the service includes

What ground tank waterproofing includes

  • Checking the tank walls, base and cold joints for cracks and weak points
  • Cleaning and preparing the internal surface before any treatment or material is applied
  • Sealing fine cracks and the cold joint between the wall and the base before waterproofing
  • Treating the internal walls with a lining that can carry the pressure of stored water
  • Treating the base and the transition zone between wall and base as a single unit
  • Assessing the external wall condition where damp soil pressure is a factor in the leak
How we work

How the work goes

  1. 1

    Tell us what you notice

    Call or message us on WhatsApp and tell us where the leak shows in the tank and whether you notice damp in the surrounding soil or a drop in the water level.

  2. 2

    Inspecting the tank and walls

    The job starts with checking the walls, the base and the cold joints for cracks and weak points before any lining is applied.

  3. 3

    Preparing the surface

    Surface preparation includes cleaning the walls and sealing cracks and any gap in the joints, because a lining is only as good as the surface it goes onto.

  4. 4

    Applying the waterproofing

    The walls and base are treated as one unit, with particular attention to the cold joint zone between the wall and the base as it is the area most exposed to leaks.

Why Al Raya

What makes this treatment reliable

  • We treat the base and walls as one unit
  • We seal cold joints before waterproofing
  • We choose a material suited to soil pressure
  • We take your request by phone call or WhatsApp message
  • Reach us by call or WhatsApp
About the area

The service in Ash Shi’bah

Ground tanks in districts like Ash Shi'bah face constant pressure from water inside and soil and groundwater outside. This pressure causes slow cracks in the base and walls, especially at corners and pipe connections. Damp in the basement or a musty smell near the tank signals a leak has started. The tank is inspected inside and out to find cracks and existing damp, then the inside surface is cleaned and a waterproof layer of epoxy, bitumen or foam is applied to stop water and damp seeping through.

Ash Shi'bah is a district in Al-Ahsa governorate in the Eastern Province, close to Al Qurayn, Julayjilah and Ash Shuqayq.

Pipe connections and the corners between base and walls are where leaks usually start first, because they are weak points under pressure.

Read about Ground tank waterproofing

Our work

Our portfolio

  • The edge of a roof insulated in white beside a building under a clear sky
  • A roof covered in a smooth white insulation layer with a small dome behind it
  • A hole in a broken wall exposing pipes and wires
  • Two workers on a large roof insulated in white
  • A roof insulated in white under a clear sky
  • A roof covered in white insulation with air conditioners and buildings around it
Reviews

What our customers say

  • ★★★★★

    شكراً لخدمتك الجميلة

  • ★★★★★

    شكرا على التواصل وصلو في اسرع وقت ممكن

  • ★★★★★

    شكرا على التواصل السريع

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Ground tank waterproofing in Ash Shi’bah

A ground tank carries the pressure of damp soil on its outer walls, which an overhead tank does not. So the walls need a treatment that can handle that additional pressure, and the cold joint between the wall and the base is more prone to cracking under these conditions.

The base receives the pressure of the stored water from above and that of damp or groundwater from below. The cold joint between the base pour and the wall pour is usually the first place a leak appears, because that joint is weaker than solid homogeneous concrete.

An internal lining protects water from escaping and treats the wall surface from inside. But if damp soil pressure is pushing water from outside in, the wall may also need external treatment. What suits each tank depends on the actual condition and position of the leak.

A fine crack in concrete does not let water through freely at first, but it widens with repeated filling and emptying as the concrete expands and contracts. When the crack reaches enough depth it becomes a direct path for water. That is why cracks are treated before the waterproofing layer, not after.

Tell us whether the tank is fully buried, partly buried or at ground level, where the leak shows such as the walls, the base or the cold joint between them, and whether you notice damp in the surrounding soil or a drop in the water level inside. These details help us identify the right treatment.

Call Al Raya at once for a tank inspection. Damp means water is seeping from the tank, and the sooner inspection and treatment begin, the less damage reaches the foundation and walls.

Inspection and treatment from inside are necessary to stop leaks at the source. Outside waterproofing alone cannot stop water entering from inside, and will not fix cracks where they started.

Nearby areas

Ground tank waterproofing in nearby areas

Sunset over villa roofs and palm trees

Call and describe your tank

Call or WhatsApp us and tell us what you notice in your ground tank.

Call nowWhatsApp