What this service includes
- Checking the roof slab, joints, drains and parapet before starting
- Treating cracks, edges and joints in the roof before the waterproofing is applied
- Waterproofing the full roof area including the zone around the tank base
- Waterproofing the tank base and outer walls on top of the finished roof
- Adding thermal insulation with polyurethane foam on the roof where needed
- Treating the shared weak points between the tank and the roof in a single job
From your call to the finished job
- 1
Describe what you see
Call or message us on WhatsApp and tell us whether the damp shows on the roof, below it, around the tank, or in all of these places.
- 2
We inspect the roof and the tank together
We check the condition of the roof slab, the joints, the edges and the parapet, then the tank base and its outer walls, because each affects the other.
- 3
We waterproof the roof first
The roof slab is prepared and the cracks, joints and drains are treated, then the waterproofing layer is applied across the full area including the zone around the tank base.
- 4
We treat the tank on a finished roof
Once the roof is ready we waterproof the tank base and its outer walls, so both layers work together and neither undoes what the other seals.
One treatment instead of two
- The tank and the roof are treated together in one complete job
- The order of the work stops one waterproofing layer from damaging the other
- We waterproof and thermally insulate according to each surface's condition
- We take your request by phone call or WhatsApp message
- Cost depends on the case, message us to work it out together
The service in Ash Shi’bah
In a home in a district like Ash Shi'bah, tank and roof work as one system for water and heat. Tank leaks may show on the ceiling or walls below, and the flat roof allows water to gather at drains and joints. Tank inspection covers the base, joints, pipes and surrounding roof, and roof inspection covers cracks, drains and the parapet-roof joint. After inspection, the tank and roof are insulated together with one material or complementary materials to achieve complete protection from leaks and heat.
Ash Shi'bah is a district in Al-Ahsa governorate in the Eastern Province, close to Al Qurayn, Julayjilah and Ash Shuqayq.
Water gathering around the tank base or at drains points to a joint problem, and this needs treatment before final insulation.
Our portfolio
What our customers say
- ★★★★★
شركه ممتازه واشتغلنا معاهم اكثر من مره وجود عاليه ما شاء الله بارك الله فيهم واعمله
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شركه ممتازه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Tanks & roofs together in Ash Shi’bah
Yes, if the roof slab is sound and the joints and drains are tight, treating the tank alone is enough. But if the roof has cracks or signs of damp, ignoring it means water will find a way through even after the tank is sealed. That is why we check both before deciding.
They suit the roof's condition and what it needs. Bitumen rolls are laid over open areas and the edges and joints are sealed. Epoxy suits the finish around the tank base and at the drains. Polyurethane foam may be added for thermal insulation where the roof is exposed to direct sun.
The tank base sits directly on the roof slab, and any water that leaks from under the tank stops only where the waterproofing ends. If the slab is bare or has an old worn layer, the water soaks into it and reaches the floor below. Over time the slab itself cracks under the accumulated moisture.
If the stain is concentrated directly below the tank, the tank is likely the cause. If it spreads across a wider area of the ceiling, the roof is the more likely source. But the two often work together to bring water to the same place, so inspection alone tells them apart with certainty.
Tell us whether the damp appears on the top-floor ceiling, on the roof surface around the tank, or both. Tell us whether the tank is concrete or fibreglass and whether water appears under its base. These details tell us where to start and which materials suit the situation.
It could be from both. If it is directly below the tank it is usually from the tank or its base, and if it is away from the tank it may be from water pooling on the roof at a joint or drain. Inspection determines the exact source.
Because water may travel from the tank under the roof and appear later, and heat from both affects the home. If one is treated alone, water may find another path or the problem returns in months.
More services in Ash Shi’bah
