What this service includes
- Checking the roof slab, joints, drains and parapet before starting
- Treating cracks, edges and joints in the roof before the waterproofing is applied
- Waterproofing the full roof area including the zone around the tank base
- Waterproofing the tank base and outer walls on top of the finished roof
- Adding thermal insulation with polyurethane foam on the roof where needed
- Treating the shared weak points between the tank and the roof in a single job
From your call to the finished job
- 1
Describe what you see
Call or message us on WhatsApp and tell us whether the damp shows on the roof, below it, around the tank, or in all of these places.
- 2
We inspect the roof and the tank together
We check the condition of the roof slab, the joints, the edges and the parapet, then the tank base and its outer walls, because each affects the other.
- 3
We waterproof the roof first
The roof slab is prepared and the cracks, joints and drains are treated, then the waterproofing layer is applied across the full area including the zone around the tank base.
- 4
We treat the tank on a finished roof
Once the roof is ready we waterproof the tank base and its outer walls, so both layers work together and neither undoes what the other seals.
One treatment instead of two
- The tank and the roof are treated together in one complete job
- The order of the work stops one waterproofing layer from damaging the other
- We waterproof and thermally insulate according to each surface's condition
- We take your request by phone call or WhatsApp message
- Cost depends on the case, message us to work it out together
The service in Al Kilabiyah
The town relies on roof tanks, and when a tank leaks, it wets the roof and the ceiling below. The leak often comes from the tank base or the joints between tank and roof, or from fill pipes and drain openings. If the roof alone is treated, water still enters from the tank, so both must be fixed at once. The team pinpoints the leak precisely, then prepares the tank base and joints afresh, and insulates the whole roof with one continuous layer of foam or bitumen rolls.
Al Kilabiyah is a town in Al-Ahsa governorate in the Eastern Province.
A close check of the tank and roof together shows whether water comes from above or below.
Our portfolio
What our customers say
- ★★★★★
شركه ممتازه واشتغلنا معاهم اكثر من مره وجود عاليه ما شاء الله بارك الله فيهم واعمله
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شركه ممتازه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Tanks & roofs together in Al Kilabiyah
Yes, if the roof slab is sound and the joints and drains are tight, treating the tank alone is enough. But if the roof has cracks or signs of damp, ignoring it means water will find a way through even after the tank is sealed. That is why we check both before deciding.
They suit the roof's condition and what it needs. Bitumen rolls are laid over open areas and the edges and joints are sealed. Epoxy suits the finish around the tank base and at the drains. Polyurethane foam may be added for thermal insulation where the roof is exposed to direct sun.
The tank base sits directly on the roof slab, and any water that leaks from under the tank stops only where the waterproofing ends. If the slab is bare or has an old worn layer, the water soaks into it and reaches the floor below. Over time the slab itself cracks under the accumulated moisture.
If the stain is concentrated directly below the tank, the tank is likely the cause. If it spreads across a wider area of the ceiling, the roof is the more likely source. But the two often work together to bring water to the same place, so inspection alone tells them apart with certainty.
Tell us whether the damp appears on the top-floor ceiling, on the roof surface around the tank, or both. Tell us whether the tank is concrete or fibreglass and whether water appears under its base. These details tell us where to start and which materials suit the situation.
No, because water will seep under the tank onto the roof again. Treating the tank and roof together is the only way to stop the leak, and this means checking the tank first, then the roof.
The tank base and walls are checked for cracks and holes, the joints around fill and drain pipes are checked, and the point where the tank meets the roof. Each weak point decides which material suits its repair.
More services in Al Kilabiyah
