How the work goes
- 1
Describe what you see
Call or message us on WhatsApp and tell us where the damp or leak is and when you first noticed it.
- 2
Finding the failure and preparing the surface
The job starts with locating where the water enters, cleaning the surface and repairing any cracks or joints before the waterproofing goes on.
- 3
Applying the right material
The material is chosen by surface and use: bitumen rolls, epoxy coating, polyurethane foam or cement-based waterproofing, each suited to what the surface needs.
- 4
Checking the layer is continuous
The work covers joints, edges, the parapet and any pipe penetrations, because water finds the weakest point in the layer.
The failure can be found and fixed
- We find the water source before any treatment
- We cover roofs, tanks, bathrooms and pools
- We use the material that suits the surface and its use
- We treat cracks and joints, not the layer alone
- We take your request by phone call or WhatsApp message
The service in Al Badriyah District
In Al Badriyah District, problems may start with a wet ceiling or mould smell in a corner, usually from a roof joint, water pipes or the tank base. The first inspection looks at the whole roof, especially around the parapet, drains and joints, and at rising and falling pipes. In Al-Ahsa, groundwater and salt often weaken lower walls too. Once the water source is found, the affected area is cleaned and treated with epoxy for fine joints, bitumen for tiled or sheet roof, or foam for wider areas.
Al Badriyah District is a district in Al-Ahsa governorate in the Eastern Province, close to Imam Muhammed Ibn Saud Islamic University District, Al Majidiyah District and Al Quds District.
Most home leaks enter through weak joints between roof sections, or around tanks and drains.
Our portfolio
What our customers say
- ★★★★★
شغلهم نظيف وسريعين ومحترمين الله يعطيهم العافيه
- ★★★★★
شغلهم ميه ميه يشكرو عليه
- ★★★★★
شركه ممتازه
Reviews are shown as the customers wrote them, in Arabic.
Questions about Waterproofing in Al Badriyah District
Roof waterproofing against rain is one type of waterproofing focused on the roof surface, its drains and the cracks that let rainwater in. Waterproofing in its wider sense also covers bathrooms, tanks, pools and foundations, each needing a different material and approach according to the surface and how much water it faces.
Yes. Bitumen rolls are usually used on concrete roofs exposed to sun, epoxy coating suits surfaces that need a hard skin such as tanks and floors, and polyurethane foam gives both waterproofing and thermal insulation together. The choice depends on the surface type, how much water it faces and the movement it is likely to experience.
Work can be done in more than one place in the building, but each is inspected, prepared and waterproofed on its own because the material and method differ. A bathroom needs a system that handles continuous moisture and movement, while a roof faces heat and rain. Once we know the full scope we explain what each location involves and what it needs.
Not necessarily. A small crack that carries no water is treated by repairing and filling the crack itself. If water seeps through it or the area faces continuous moisture, additional waterproofing after the repair may be needed. Inspection is what decides the extent and the material required.
The water may come from a source other than the roof, such as pipes inside the wall, rising damp from the ground or a leak from a nearby joint. What looks sound from above may also hide a crack in the parapet or a structural joint that was never waterproofed. That is why the stain's position alone does not identify the source.
Water-resistant paint reduces surface absorption but does not form a continuous barrier and does not cover cracks or joints. Real waterproofing forms a connected layer that blocks moisture from both sides and treats the weak points in the surface. Paint may hide the problem for a time but does not treat it.
If the problem is damp or water stains on the ceiling or wall, waterproofing comes first. If the problem is heat on the top floor in summer, thermal insulation is what you need. Both often appear together on the same roof, and polyurethane foam, for example, serves both purposes in a single layer.
A leak that only happens in rain, or a pipe that only leaks at certain water pressure. The team inspects the roof, pipes and tank, and asks exactly when the patch appears: after rain, after heavy water use, or every day. This identifies the cause.
A hidden pipe in the wall gives concentrated damp in one spot. Damp spread across the whole lower wall may come from the salty groundwater common in Al-Ahsa. The team asks and inspects to identify the source before starting treatment.
More services in Al Badriyah District
Waterproofing in nearby areas
