
What ceramic roof coating includes
- Inspecting the concrete roof to confirm it is free of cracks and standing water before application
- Cleaning and drying the surface and removing dust and loose material in preparation for coating
- Treating any minor weak points in the concrete before the layer is spread over them
- Applying the light-coloured ceramic coat across the full roof area after the surface is ready
- Ensuring the roof edges and the areas around the parapet are covered within the scope of the work
- Answering any question about the roof's condition and whether it needs additional treatment before or after coating
From your call to a coated roof
- 1
Tell us what you see
Call or message us on WhatsApp and describe the roof: whether there are visible cracks and which rooms feel the hottest.
- 2
Inspecting the roof
We check the roof to confirm it is sound, free of cracks and without areas where water sits, because the coat needs a good base.
- 3
Preparing the surface
The concrete is cleaned, dried and any minor weak points are treated before coating, because a layer that does not bond well cannot do its job.
- 4
Applying the ceramic coat
The light-coloured coat is spread over the whole roof area once the surface is ready, to reflect solar radiation and protect the concrete.
Your roof is in hands that inspect before they coat
- We inspect the roof before any application
- Ceramic coating reflects solar radiation directly
- Suited to sound concrete roofs
- It sheds water and protects the concrete
- We take your request by phone call or WhatsApp message
The service in Haradh
In a town like Haradh, heat beats down on flat roofs all summer, and roofs often carry tanks, joints and parapets. The ceramic coat covers the existing surface without breaking it up, reflecting sun heat and protecting the concrete from thermal cracking and light damp. The roof is checked before coating to ensure the concrete is sound and free from large cracks that need separate repair.
Haradh is a town in Al-Ahsa governorate in the Eastern Province, close to Ash Shuruq, Al Ekhaa and Ar Rabie.
The ceramic coat reflects heat from the roof, so the concrete is checked first to ensure it needs no repair before coating.
Our portfolio
What our customers say
- ★★★★★
ممتاز والخدمة ان شاء الله تكون قد التوقعات
- ★★★★★
شركه ممتاز شغلهم كويس ويعطيهم العافيه
- ★★★★★
شكراً لخدمتك الجميلة
Reviews are shown as the customers wrote them, in Arabic.
Questions about Ceramic roof coating in Haradh
No, ceramic coating is a protective layer applied to a sound surface. Cracks need separate treatment before the coat goes on, because the coat alone does not fill a crack or stop water entering through it. A roof with cracks needs a different insulation system.
It suits mainly sound, exposed concrete roofs that have no cracks and no standing water. Tiled roofs or roofs with an old worn layer need assessment before a decision is made.
It protects a sound surface from water absorption and sheds light rain, but it is not a substitute for full waterproofing when the roof has weak points or cracks. If there is a damp stain on your ceiling, the roof needs a deeper inspection first.
Ceramic coating is a thin layer that reflects solar radiation off the roof surface. Polyurethane foam is a thicker sprayed layer that absorbs heat and insulates the concrete slab from within. Roofs with severe heat or with cracks may need the foam or a different system.
Tell us whether the roof is bare concrete or tiled, whether you notice cracks or areas where water collects, and which floor feels the hottest. The cost depends on the condition and area of the roof, so send us a WhatsApp message with what you see.
Ceramic coating protects a sound roof from heat and water, but it does not repair deep cracks. If your roof has wide cracks, they must be repaired first before coating.
Say that the top rooms heat up in summer, whether you see cracks or damp stains on the roof or ceiling, and send a photo of the roof on WhatsApp if you can.
Ceramic roof coating in nearby areas
















