Al Raya
Cementitious tank waterproofing in Juba District: A brush applying grey cement-based coat to a concrete tank wall

Cementitious tank waterproofing in Juba District

In Juba District, concrete water tanks absorb moisture from the ground and water pressure from inside. Al Raya coats the tank walls with a cementitious layer that penetrates the concrete's pores and creates a barrier against leaks.

What the service includes

What cementitious tank waterproofing includes

  • Checking the concrete tank walls to find cracks, pores and leak points
  • Cleaning the inner surface of dust, algae and residue from old coatings
  • Roughening the surface so the cementitious coat grips the concrete wall firmly
  • Treating fine cracks and structural joints before the waterproofing coat is applied
  • Applying the cementitious coat to the dampened wall with care at corners and edges
  • Reviewing the surfaces after application to confirm the coat covers the full wall area
How we work

From your call to a sealed wall

  1. 1

    Tell us about your tank

    Call or message us on WhatsApp, and describe the tank size, its location and what you notice: any damp or cracks in the walls.

  2. 2

    Preparing the concrete surface

    The walls are cleaned of dust, algae and old coating residue, then the surface is roughened so it takes the cementitious coat well.

  3. 3

    Treating cracks and joints

    Fine cracks and structural joints are treated first, because the waterproofing coat alone cannot close an existing crack.

  4. 4

    Applying the cementitious coat

    The cementitious material is applied to the prepared and dampened wall so it absorbs into it, and is worked again over edges and corners for full contact.

Why Al Raya

Concrete and cement work together

  • The coat bonds with the concrete tank wall
  • Works on damp walls that are hard to dry fully
  • Seals pores and penetrates the concrete from within
  • We treat cracks and joints before the coat goes on
  • We take your request by phone call or WhatsApp message
About the area

The service in Juba District

Family homes in a district like Juba usually have concrete tanks in the basement where the ground stays damp much of the time. The salt and dampness in local well water weaken the walls from outside and allow water to seep through fine cracks. The team inspects the tank from the outside to find cracks, damp and salt deposits, then cleans the wall of decayed material and salts, and applies cementitious coating in even layers that fill the pores.

Juba District is a district in Al-Ahsa governorate in the Eastern Province, close to Al Mirqab District, Ladhah District and Al Marbidia District.

Damp from below weakens concrete faster than water pressure from above, so the first check focuses on the tank's lower wall.

Read about Cementitious tank waterproofing

Our work

Our portfolio

  • Damp stains and damage on a ceiling beside a wall light
  • A hand scraping damp mortar from between small stones on a surface
  • Peeling paint on an exterior wall beside a pipe
  • Cracked and bubbling paint along a wall edge
  • A white roof with an air conditioner and satellite dishes
  • A leak detection device with headphones in a case
Reviews

What our customers say

  • ★★★★★

    شغلهم ميه ميه يشكرو عليه

  • ★★★★★

    شكرا على التواصل السريع

  • ★★★★★

    شغلهم كويس وناس ممتازه في اسرع وقت

Reviews are shown as the customers wrote them, in Arabic.

Questions

Questions about Cementitious tank waterproofing in Juba District

The cementitious material needs moisture in the surface to absorb into it and bond with it rather than drying out on top. If applied to a fully dry wall in the heat, the coat dries before it can penetrate the concrete and the result is weaker.

Yes, cementitious waterproofing systems are designed to resist water pressure from both sides, inside and outside. That is the main difference between a true waterproofing material and a plain cement paint. The surface must be clean and free of old coatings that block bonding.

It depends on the state of the old lining. If it is sound and not peeling it may be assessed for keeping, but if it is loose or flaking it must be removed first, because the cementitious coat needs direct contact with the concrete, not with a failing old lining.

The tank must be emptied, cleaned and prepared before waterproofing in any case. The main advantage of a cementitious material is that it works with damp concrete and does not require the complete dryness that some resin-based materials need.

Tell us whether the tank is a ground tank or an overhead tank, what you can see such as seepage in the wall, damp at the base or a peeling old coat, and whether the tank is currently in use or empty. This helps us assess what the surface needs before the cementitious coat.

A basement tank faces constant ground dampness, so its outer walls need careful inspection for fine cracks. The cementitious coating works the same way, but preparing the wall is even more important.

Tell them the tank is in the basement, whether you have noticed damp or smell near it or on the floor beside it, and send photos of the tank's outer walls on WhatsApp.

Nearby areas

Cementitious tank waterproofing in nearby areas

Sunset over villa roofs and palm trees

Call and describe your tank

WhatsApp or call us and tell us what you see on your tank walls.

Call nowWhatsApp